Questions & Answers for: Whirlpool duet warped washer tub

warped. Remove the lower kick plate and watch the shocks during the spin cycle. The shocks should vibrate some, but should not be excessive to the point that it causes an unbalanced spin. To check the

...tub, i would also replace the inner stainless basket as well, (your in that far and if it was for noise issue, not a bad aidea, ahte to put back topgether and find the rear bearing has warped the ...

...tub port, open the washer's main access panel and remove the large-diameter rubber hose that connects the pump to the bottom of the outer tub. Then, using needle-nose pliers, try to grab and remove ...

...tub port, open the washer's main access panel and remove the large-diameter rubber hose that connects the pump to the bottom of the outer tub. Then, using needle-nose pliers, try to grab and remove ...

...washer tub shell. 4. Insert the upper shell support springs into the wash tub and support spring brackets. 5. Raise the washer casing to the upright position, making sure the tub does not swing ...

...tub abd Basket of your washer. The basket is held onto the rear half of the outer tub simply by the bolt to the main pulley. Remove the bolt, remove the pulley, and the basket shaft should slip right ...

Washer is 5 years old and is making alot of noise during final spin. Serviceman replaced the shocks but did not solve the problem. He checked everything else and said was ok. Now they tell me the drum

...washer tub shell. 4. Insert the upper shell support springs into the wash tub and support spring brackets. 5. Raise the washer casing to the upright position, making sure the tub does not swing ...

...washer tub has a wobble to it. I checked the tub between loads and the tub seems to have quite a bit of free play in it. We are now getting any error cosde displays and the clothes are as clean as ...

...washer tub shell. 4. Insert the upper shell support springs into the wash tub and support spring brackets. 5. Raise the washer casing to the upright position, making sure the tub does not swing ...