...tub, i would also replace the inner stainless basket as well, (your in that far and if it was for noise issue, not a bad aidea, ahte to put back topgether and find the rear bearing has warped the ...
...washer wont spin because the tub is so warped that when it spins its so out of balance then ok new tub.or the tub welds are broken and some part is dragging and not letting it spin then ok new tub.or ...
Question about 3.8 cu. ft. HE3 Front Load Washer
...warped and also tub bearing and spin basket could be bad. dont have your specific model # to know if in warranty . can go to wpl .com and check warranty with your model # or kenmore then go to ...
Question about Duet GHW9150P Front Load Washer
Washer is 5 years old and is making alot of noise during final spin. Serviceman replaced the shocks but did not solve the problem. He checked everything else and said was ok. Now they tell me the drum
...washer shakes. The plastic tub seem to be the problem. I took the front off and watched it spin. The tub seems to want to lean to one side and spin out of round moving up and down. All springs are ...
Question about Atlantis MAV6000 Top Load Washer
...Washer will run fine with nothing in it, but as soon as you put some weight on the drum it will not work. I got the machine used, and it has never finished a cycle without doing the UE error code. ...
...washer, clean it. Also check the tub seals. Some washers have a seal on the tub or the door. And a bottom door seal. If they are warped or damaged it could leak. Also check your leveling screws. Make ...
Question about 3.5 cu. ft. King Size Capacity Top Load Washer w/PerfecTemp System
washer constantly sounds unbalanced could be a warped tub or shaft. If unit is not under warranty, could get a little costly to fix. Also, the dampers could be weak as well. Dampers are a cheap enough
Question about Atlantis MAV6000 Top Load Washer
my maytag alantis washing machine tub goes evey were the tub is not stable goes every were Check balance spring adjusters are locked off. Could be the base warping, if so it will need replacing.
Question about Atlantis MAV6000 Top Load Washer
...tub is not level. could it be the suspension rods prob need replaced Some models the bowl is suspended from the top, check all springs & shafts are connected. If the washer bowl is suspended from ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions