Questions & Answers for: sony kdf e42a10 bright

Sony KDF-E42A10 Screen is Not Bright My Sony KDF-E42A10 LCD HDTV has suddenly become very dark and I cannot adjust it. Up until now the picture has been bright and clear and could even be watched with

...bright, so I'm thinking it's not a lamp problem. Tried to call Sony, they said to unplug the TV 5 minutes and plug it back in to the wall (no power strip). I tried that, had no effect. Any help would ...

Yellow circle we heard a loud pop, now we have a hazy yellow circle in the center of the picture, I replaced the bulb. There are a couple of things that this could be caused from.. Its hard to say ...

...sony KDF-E50A10 and the picture is fading The picture is dull in it has no brightness to it. Have adjusted the factory settings still dull, Could this be the lamp? check the lamp timer in the menu ...

...Sony Wega HD KDF E42A10 easy enough for someone who's pretty handy? It is not recommended...not even for a service tech unless there is a definite need. I think some people think that this affect the ...

i try to turn it on but it just blinks on stand by Probable Lamp. If lamp hasn't bown the red Lamp Lite won't flash but other lamp issues cause stby timer light to continue flashing. If stby red lite ...

...sony kdf-e42a10 TV. I have a bright blue blotch about 2''x4'' on the lower right quarter of the screen. It looks ''over exposed''?. I put on a a no signal ''snow'' and it appears to be migrating ...

picture is too dark. tried adjusting via remote but it says brightness is @ Max. is there a manual control on the set that might help? Thanks for any guidance. your bulb is coming to its end of life ...

T V will not turn on. LAMP light turns on when I press the on button. Each LCD display has a lamp. Which literally allows the display to be bright. If you see a display that says LAMP it means that ...

...bright and hot lamp hits inside the engine is the BLUE SECTION----damage occurs and you get blue streaks or area anywhere on picture.Damage is permanent and only way is to replace 800 +  ...