Questions & Answers for: Jeep how to remove do not disturb

Question about 1993 Grand Cherokee

1 Answer

...remove the battery negative cable before getting in there to mess with it, there are airbag things you don't want to disturb while working in the area, let the car sit for about 5 minutes before ...

Ad

...with the distributor properly installed-1987-90 2.5L engine Disconnect the negative battery cable. Remove the primary lead from the terminal post at the side of the distributor. The wire connector ...

Ad

Question about 1990 Wagoneer Limited

1 Answer

...new battery replacement, the power that keeps the electronics in the instrument panels is instantly removed, and this means that during the time when the battery is reconnected (or when a new battery ...

gasket says "no sealent needed" , is this true? On the fuel rail there is a small cap that you will remove, inside is a schradervalve(like on a tire stem)depress it with a small screwdriver to relieve

Question about 1993 Grand Cherokee

1 Answer

...connection. It could be the battery cables, or the terminals. if they are top mount batt terminals, remove them and scrape the inside of the terminals with a pocket knife, to make sure there is no ...

Question about 1999 Grand Cherokee

1 Answer

...housing the axles. If an axle were to be changed then the differential cover would have had to be removed to access the components. I just find it somewhat unusual that the cover was not taken off ...

Question about 1993 Cherokee Country

1 Answer

remove the pump assembly from the block. Discard the gasket. WARNING If the oil pump is not to be serviced, do not disturb the position of the oil inlet tube and strainer assembly in the pump body. If

changed head light now power windows don't work, alarm goes off, other electrical issues happening check that you have not disturbed any earth wires or removed them and not refitted them

...brake booster on my 2000 Grand Cherokee,and I have no brakes. There were no leaks and I didnt remove the brake lines upon removal of the old booster. Any suggestions? hello i just installed my ...

idling very high n wont come down. why is that ? after i put a throttle body gasket on. If you tighten one side down before the other this could be an air leak. Loosen it, snug up one corner, then the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...