Question about 2000RS Remote Control
...5 times the siren or horn will sound,then push switch 21 times and hit button 2 on remote then turn key off .this sets to gas engine.then start car do the same thing but press button 1 led should ...
...procedure programs the remote control part of the key. Any transponder chip for the immobiliser (starting of car) will not be programmed and must be done by a specialist. how about on a 2007 bmw ...
Question about Car APS997A Two-Way Remote Start and Security System
...5 seconds tunrs off. I have the remote start on my 06' chevy impala, when i use the remote start the car will turn on and it automatically turns off 5 seconds later. If anybody has any idea on how to ...
...starting with lock. Use an even pace and try to go about one cycle per second. (1Cycle = 1 lock and 1 unlock). B. Insert the key in the ignition cylinder. C. Turn the ignition to ON (Do NOT Start) ...
...5 seconds. Turn off and remove key. 8. Locks should cycle once (Car will lock and then unlock once). If they don't cycle or they cycle more than once, do steps 1-7 over. 9. Now using the remote, push ...
Question about 1401 Remote Start/Keyless Entry System
...remote is now ready to pair. 3.. Turn the key to the on position 4.Within 5 seconds PRESS AND RELEASE the control button on the antenna. 5. Within 5 seconds PRESS AND HOLD the control button. The ...
Question about 1401 Remote Start/Keyless Entry System
...starting with lock. Use an even pace and try to go about one cycle per second. (1Cycle = 1 lock and 1 unlock). B. Insert the key in the ignition cylinder. C. Turn the ignition to ON (Do NOT Start) ...
Question about 1401 Remote Start/Keyless Entry System
...remote, you should follow the same sequence with the exception of step 6; instead of turning the key to the 'on position' and back to the 'off position' 5 times in 5 seconds or less, do it 3 times in ...
remote starts jeep but dies after 5 seconds starts quick , but only runs for about 5 seconds. try it again and only beeps but nothing else if any code turns on a fault (engine light) then the remote ...
Question about 2011 Patriot
...remote control. 5. The horn honks to confirm the remote has been programmed. 6. Release the Valet button, and turn the key to the Off position. 7. The horn sounds one long honk to confirm that remote ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions