...froze up where the washer was located then it is possible that the pump or supply lines also froze because they always have water in them. The repair price will vary with whoever you call to fix
Question about WM1814CW Front Load Washer
...pump wont rotate, froze up. i have a diamond shallow well jet pump model # SJC50, 230V, 4amps, 60Hz, .5 HP that froze up and wouldnt turn over. I've taken it apart and dont see anything that would ...
...froze, Electrical problem ? Need Help AL YOU NEED TO PUMP DOWN SYSTEM WITH VACUUM PUMP.CHECK FOR LEAKS.IF YOU DONT PUMP DOWN SYSTEM TO REMOVE AIR OR MOISTURE THE COMPRESSOR IS NOT GOING TO WORK
...leak. Once you remove it and try to free spin it you will be sure but I say since the belt is off and it's froze, your chances are almost 100% that the pump is bad. I hope this helps and good
...looks the same as if it was a new car either the bearing in the water pump froze up, or the bearing in the tensioner froze, this can also cause the serpentine belt to be thrown off of the
...it to see water in the top part of the motor. I sealed it and pump ran for 1 day and then ot froze I THINK THE BEARING IS FROZE UP. YOU WILL HAVE TO TAKE TO A PUMP REPAIR SHOP AND HAVE IT LOOK
Question about 3/4hp Super Pump Inground Pool Pump 115/230 Volt # Sp2605x7
impellor was froze so took it apart and spun it, motor now just makes a humming noise and impellor doesnt spin impellor was stuck or froze so took it apart and got it to turn with some force, stil ...
ac belt smoking either your belt tenstioner pully is froze up or your ac pump is froze up. loosen belt and see which on does not move
Question about 1993 Lebaron
...pump froze. do i need ac belt, has seperate serpintine belt. need to know if possible. if the pump is froze and u put a new belt on it it will burn the belt off in a matter on min, sounds like you ...
Question about NTW4650YQ Top Load Washer
...pump be froze or is there a reset button I don't know about? If the lights are not coming on, but you hear the pump, it could be stuck in the force drain mode. Let it run for about 2 minutes and see ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions