Questions & Answers for: maytag washer slow spin cycle

Question about MAV7600 Top Load Washer

1 Answer

...slow spin and the spin cycle is a fast spin. It just starts turning the whole drum. It used to turn off immediately when I'd open the lid but now it spins til it stops. Is this washer worth fixing? ...

Ad

Question about Atlantis MAV6451 Top Load Washer

1 Answer

...Maytag won't answer any questions until I open my checkbook. Thanks! hi thanks for the question with any washer if you use a hi sud zing detergent it really slows down the spin cycle check this just ...

Ad

Question about Neptune MAH5500B Front Load Washer

1 Answer

washer spin is very slow no matter what setting you put it on. Hi joystoy I would start with the belt. it sounds like the belt is going and that is the least expensive to fix. try that, if that doesnt

Question about PAV2300 Top Load Washer

3 Answers

Maytag Bravos Washer - I have the same problem. It cost as much to change the spin bearing as to buy another washer. Sounds like an airplane landing in my home when it goes on spin cycle. Remember its

Question about Atlantis MAV6000 Top Load Washer

1 Answer

Slow spin cycle, clothes still very damp My Maytag MAV6000AWW started leaving clothes very damp after they were done. Wife said it seemed like the spin cycle was slow. I checked and yes it is slow, ...

Question about PAV2300 Top Load Washer

1 Answer

slow spin at start of spin cycle Washer fills correctly and agitates very well. When the timer reaches the spin cycle it starts very slow and if left operating the tub remains almost full. I chacked ...

Maytag top loading washer 1994 does not spin during rinse cycle Hi, My Maytag top loading machine circa 1994 does not spin on the "spin cycle". It does pump the water out. The "wash cycle" turning ...

Question about PAV2300 Top Load Washer

1 Answer

...Maytag washer Performa PAV2300AWW. When it is in spin cycle it runs slow. The load is still wet. Any suggestions? Thanks, David new belt or there is a thrust bearing above the drive pulley that wears ...

Question about MAH6700AWW Neptune Front-Load Washer

1 Answer

Why slow spinning? What causes washer to spin slowly and stop in the middle of the cycle, code E3 sometimes appears. a slow spin sometimes indicates that a out of balance switch might be ...

Maytag washer is sometimes out of balance and clothes are sopping wet when spin cycle ends. Washer is balanced on the floor. 1ST thing put less clothes in washer each time second ck to see that drain ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...