Questions & Answers for: Jeep iac sensor Cars & Trucks

...sensor the adjustment is controlled by the computer there is no adjustments.What kind of problem are you having? if it is stalling then i would replace the iac if you have then check the battery a ...

Ad

Question about 1995 Wrangler

2 Answers

IAC or vacuum hose leak the O2 sensor will see this extra air and add fuel to compensate to maintaim a 14.7 to 1 ratio but also the computer will see your foot is off the gas and the throttle position

Ad

...sensor etc Don't replace the iac before you test everything. the TPS, MAP and O2 sensors as well as the coolant and manifold temp sensors have far more to do with your problem than does the IAC which ...

Question about 1991 Cherokee Briarwood

1 Answer

...iac motor 2. Crank Shaft sensor still the same Problem. P0505 - Idle Air Control System Malfunction The PCM attempts to control engine speed during KOER self-test. The test fails when the desired rpm ...

Question about 1996 Grand Cherokee

3 Answers

IAC) sensor/motor. This sensor is located on your vehicle's, throttle body. The purpose of this sensor is to control the car's idle under various operating conditions including ambient temperature. In

Question about 1999 Grand Cherokee

3 Answers

where is the iac valve located on my 1999 jeep grand cherokee 6 cyl or v8 Removal & Installation 3.7L The Idle Air Control (IAC) motor is located on the side of the throttle body. Disconnect ...

Question about 1996 Grand Cherokee

1 Answer

...iac not working If you have not done so pull the engine codes or have someone do it.The codes will give you a good idea where to start otherwise the first place I would check is replacing the ...

...sensor it ran fine for the week. But now it's stalling again, what else could it be? I've had it diagnosed by car repair shops and autozone. You replace sparkplugs,plug ...

...IAC with a DMM...this will be in a chilton/Hanes guide. You can also spray MAF cleaner onto the MAF sensor within the MAF however, if the MAF goes out the car usually will not start. (Do Not spray ...

IAC valve ---ECM code p 2767 refers to transmission input shaft speed sensor/turbine shaft speed (TSS) sensor B---no signal===causes --wiring---transmission input shaft speed sensor /TSS sensor diesel

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...