Question about STA-RITE IMPELLER 2HP FULLRATE & 2-1/2HP UPRATE, C105-238PEB
...rite well pump runs fine but does not draw water (or very little.) everything in the well has been check out (ok) some water leakage from upper portion of punp. (seal?) would appreciate any advice. ...
...is a screw in the center of the impeller, that is left handed and unscrews by turning clockwise. then unscrew the impeller and replace the seal. Reassemble pump with new "O" rings and fill with
Question about Corrosion Resistant Shallow Well Jet Pump 1/2HP, 8GPM
...Rite Pump 1 hp, 230 volt model DS3HE - 01 runs, but does not operate my irrigation system with any pressure. I resume the pump has lost its prime, but have no clue as to what I might do to fix it? ...
Question about 1 HP Sta-Rite Pump: 1.5" in/out, Center Discharge, 240V, w/Hair & Lint Pot
fill the pump before you try starting it up, especially with a new (dry) seal. It is best to replace all seals, gaskets and orings at the same time if replacing the shaft seal. Use a Pump Kit like Sta
Question about 1 HP StaRite Pump 15" inout Center Discharge 240V wHair Lint Pot
...pump and turned it on and it only hums. It's hooked up correctly. Does it need water in it? Yes. Remove the basket top and fill it with water ... as much as it will take ... replace the top and try ...
Question about STA-RITE IMPELLER 2HP FULLRATE & 2-1/2HP UPRATE, C105-238PEB
...Rite Sand Filter Pump. We've tried priming the Jacuzzi Magnum Plus pump but it won't pull water. We had to completely drain and power wash the pool as the owners spouse passed and he did not ...
...fill up the tank with water (about 3 gallons?)first this gives the pump suction it needs to start pumping IF YOU don't prime it it will burn up the shaft seal (in just a few minutes) and it will ...
Question about 1 HP Sta-Rite Pump: 1.5" in/out, Center Discharge, 240V, w/Hair & Lint Pot
Rite irrigation well pump MSE-6M82 turns on but no water. How do I prime the pump? 1 HP 115/230 V Motor C48L2FC4VHC3 there's a small plug on the side of the pump. fill a gallon of water, plug back in.
...Rite BHR170 sand filter. We have cleaned and filled the pool, added the chlorine, and turned on the pump, and water gushed everywhere. I think the hose set-up is incorrect? in form skimmers out to ...
...up? When I turn the pump to filter - which I assume is the first thing I'm supposed to do after filling the pool - water gushes out. I also need to know how may pucks to put in at a time. in from ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions