Questions & Answers for: electric oven control falling

...electric with a smooth rangetop (no exposed burners), stainless steel/black, with a storage drawer under the oven. Can anybody help a frustrated widow who's lost in the kitchen - with a dirty oven?? ...

...control knobs keep falling off. One of them I can't get the little handle tight enough to keep it on, and the other one the plastic backing has broken because of it falling off Hi, Elan oven has ...

...control oven...touch pads to set temp? May have a bad ERC. Electronic Range Control. Also check oven sensor. This is steel rod in oven in back wall near top on left or right. Check ohms from the rear ...

oven, or inside the control compartment of the oven. If you open thecontrol area, you can look at the sheet and know what failed by the list of fault codes. Unfortunetly, it could be the control board

...oven door 3) Remove the side trim screws and pull the trims down and out. 4) Remove 2 screws on the sides of the control panel. 5) Open the Microwave door. Remove the 3 screws on the Air Vent Plastic ...

oven racks. Remove the bake element. Be careful and not let the wires fall back into the holes when you remove them from the element. Use a volt/ohm meter set for ohms or continuity to check the broil

...electric oven keeps raising the temperature. It burns all foods even when the temperature is only set to 75 degrees. The type is ct9 and the model is CK 404 replace the thermostat------It controls ...

control panel, the wall oven needs to be pulled out about 10-12 inches to access the conrtol panel..it has screws on the side AND in the back of control panel taht have to come off to get into panel..

...Electric Oven won't bake after using self-clean! We ran the self cleaning on our electric Kenmore range last night, worked as it was supposed to. Now when we try to turn on the oven, the ...

electric convection wall oven? Model # FGEW3065KWA There are no error codes. Broil works, the safety is not popped, tried the control board - not it. Oven heats to temp and takes a long time because I