Questions & Answers for: drum bearings

Question about F1045W Front Load Washer

1 Answer

...drum by hand? if so bearings are not seized. can you hear motor rotate when you select spin? if not, then likely cause is motor brushes. do these simple tests and get back to me if you want. and ...

Ad

Question about F1045W Front Load Washer

2 Answers

drum bearings. Drum bearing failure is common on many washing machines due to water getting into them if the drum bearing seal fails. (Hotpoint and Zanussi in particular in my experience) To check for

Ad

Question about F1045W Front Load Washer

1 Answer

...drum. (When the bearings have gone bad, the noise is constant the entire time the drum is spinning.) Step 3Look for obvious dents and creases in the drum or look for coins or small objects stuck ...

Question about ZWF1430W Front Load Washer

1 Answer

drum bearings. Drum bearing failure is common on many washing machines due to water getting into them if the drum bearing seal fails. (Hotpoint and Zanussi in particular in my experience) To check for

...bearings and the seal that sits around the drum shaft and protects the bearing. Check the brass collar on the drum support thats sits in the bearing is not worn or grooved.If it is the shaft and/or ...

Question about ZWF1430W Front Load Washer

1 Answer

...cycle. Drum bearing failure is common when the bearing seals start allowing water to enter. You can take the belt off and spin the drum by hand, and if the drum rumbles, replace the bearings. ...

...bearings If it has drum brakes, you'll need to take off the center dust cap, remove the cotter pin, remove the nut and washer holding the drum on. The outer bearing should fall out, the inner bearing ...

...drum. When the bearings have gone bad, the noise is constant the entire time the drum is spinning. Take the belt off and run the motor alone if you hear a high pitched squealing noise to check for ...

Hi Gene, I have an Electrolux FEX831C30 stacked washer and dryer. the drum in the dryer has completely come loose and has dropped to the bottom of the dryer cabinet. there were two screws in the drum.

Why is it now squealing when in spin mode If your dryer is the kind with rotating drums, might be a bearing. You should disassemble it and check if can be replaced Dryer Repair Replacing the Drum ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...