Questions & Answers for: Jeep where is the clutch bleeder

clutch pedal 3 times with the bleeder screw closed...then hold the pedal down and open the bleeder screw. Don't release the pedal until the screw has been retightened...continue this process untill no

Ad

clutch not disengageing on 1996 jeep cherokee How do i bleed the hyd for the cltch that has a slave cylindar? I dont see any bleeder screws by the slave cylindar. There has to be a bleeder there ...

Ad

...clutch housing is the valve, or bleeder screw.If there is a dust cap over the screw, remove it, get a jar and a small clear plastic hose, put about 1 inch of break fluid ( that's what it uses) in the ...

Question about 1988 Cherokee

2 Answers

clutch action. there is a bleeder valve located above the slave cylinder inlet on the side of the trans. you will need a length of clear tubing and a bottle to drain into, as well as a bottle of fresh

...clutch on my 1992 jeep wrangler and need to know were to locate the bleeder insert The bleeder valve will be on the slave cylinder. Follow the hydraulic line from the Master Clutch cylinder down to ...

...bleeder screw and release clutch pedal. Repeat bleeding procedure until fluid entering container is free of bubbles. DO NOT allow reservoir to run out of fluid during bleeding. Refill clutch master ...

...clutch pedal in. Close the bleeder screw and let up on the clutch. Do that until the clutch pedal has a good feel. Be sure to check the reservoir frequently as they don't hold much fluid and if you ...

Question about 1996 Cherokee Sport

1 Answer

...clutch the fluid level will drop.There is a bleeder screw at the slave cylinder.Basically you can pump the pedal and hold it down while someone opens the bleeder.Close the bleeder when pressure is ...

Question about 1992 Wrangler

1 Answer

...Can't find any pictures. There is only one bleeder valve on the clutch slave cylinder so you can't be loosening the wrong part if you're opening the bleeder valve on the slave

Question about 2007 Compass Limited

1 Answer

...clutch pedal stop positions. 10. Close the bleeder valve and disconnect the service filling machine. 11. To remove remaining air, actuate pedal 10 times slowly between pedal stop positions. 12. Check ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...