Questions & Answers for: burner turning everything black

...burner then the display shuts off There is a problem with the 220v power to the stove. Indications are the neutral connection is missing either at the stove, in the plug receptacle or in the breaker ...

...everything worked just fine before, it is hooked up to natural gas, the ignitor clicks but will not light burners any suggestions. Hi I have a GE X44 gas stove. The 4 top burners work just fine, but ...

...burner knob on the right side is stuck and it won't turn. I've tried everything and can't get it to work. I had the same issue. Take the lid assembly off and remove the metal shield over the burner ...

burner. The new style tanks have a safety valve on the inside of the tank that shuts the gas off if you turn the knob on too fast because the safety valve thinks there is leak. Shut everything off and

...burner assembly out, had continuity tested and everything but the ignitor checked out. Believe the ignitor burned up when a charcoaled mouse was discovered in the burner tube. Have installed the new ...

...burner fires and everything seems fine . The burner stays on for a few minutes and shuts off like it's supposed to . After a few minutes , the glow element turns on to fire the burner again but the ...

...burner not turning off would have to do with the pressure switch, flow switch or the thermostat. With a pressure washer like this the power in the electrical system will run through these different ...

burner (not the boiler). Put everything back together and test fire it. If your boiler has not been cleaned in the last year, change the filter at the oil tank. If it continues to lock-out, change the

...everything in my smoker. There was soot built up on the bottom of the chip pan blocking the vents. Even the racks are covered with this soot. If I turn up the gas enough to get the temperature above ...

...everything on again, but nothing has helped. There is a small glass peephole roughly in the middle of the mechanism (when the cover is off) that I assume is the burner view port (though the manual ...