beater bar won't turn If you hear the motor in the head running and the beater bar isn't rotating, you probably need a drive belt. With the power off, make sure you can rotate the beater bar freely by
...beater bar won't come back on. While vacuuming I took in something that siezed up the beater bar...so I turned it off. After pulling out the stuff I turned it back on only to discover that the beater ...
Question about Cascade 140 Bagged Upright Vacuum
beater bar is not engaged. When you tilt the handle back, the clutch engages and the beater bar begins to turn. There are two likely possibilities for the "screaming noise". First, and most likely, is
...beater bar will not turn Hello rebh. Generally when the vacuum beater bar will not turn it is because the belt that turns this beater bar has broken. That said, most of the dyson's require you to buy ...
Question about EL8502 Versatility Bagless Upright Vacuum
...beater bar has seized. 1. Turn off the power (unplug). 2. Remove the bottom plate. With the plate off, use your finger to test the tension of the belt. It should be tight, and roll when you roll the ...
...beater bar by gripping the belt side of the beater bar and carefully lifting it out. • Remove worn or broken belt. • Clean beater bar and the end caps. • Loop new belt around motor shaft and beater ...
Question about XV11 Vacuum
...and that the bar housing area is free of obstructions. Note, when I said "beater/brush", it could be either/or, depending on whether you're using the "standard" beater bar, or the upgraded pet
Question about XV11 Vacuum
...beater bar brush. Turn it over and use a screwdriver or knife, and run it the full width of the beater bar to remove the hair and string and other debris that get wound up on the beater bar-NOTE you ...
...beater bar belt or the motor shaft belt? If so, you need to set the vacuum in a horizontal configuration and turn the vacuum upside down. Next remove the five screws from the base plate and lift the ...
beater bar switch on the top of the unit next to the on/off button does turn the green light on/off as it should, and the bar will turn(with a bit of resistance) by hand. (& yes I have tipped the body
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions
