Questions & Answers for: ao smith spa pump works

...Smith spa motor for an inground spa. The low speed works fine but is not strong enough to prime the system. When I switch to high speed the pump runs for 2 seconds then shuts down. Electrical circuit ...

...spa pump shuts off Newly installed 2-speed spa motor shuts off after about a second after being switched to high speed. Does not trip breaker so apparently inside the motor. Low speed works ok. Pump ...

...Smith motor problem Hums on low and cuts out. If you can turn it to high before it cuts out then you can switch back to low and it still stays engaged. I thought maybe it was a capasitor problem but ...

...and checked all possible causes. Could it be the relay switch on the control panel . AO Smith /Century pool pump (Jandy control panel) could be the start capacitor or run capacitor on pump

spa pump. Only the low speed seems to work. I have back-tracked all switching. The correct voltage is getting to the correct motor terminals for low and high speed operation. I isolated the motor from

...works but the high speed only makes a humming noise. SOUNDS LIKE A DIRTY START SWITCH OR CAPICITOR. THES MOTORS ARE NO JOKE AS I'M SURE YOU ARE STILL FEELING THE PAIN OF THE PURCHASE PRICE.. LOOK FOR ...

...should also be wrapped with black tape. If this causes a problem because you now have no low speed for the spa then the only way to get the low speed is to squire a 2 speed motor. I hope this

low speed these are a hard motor to work on. i would suggest unplug it from the motherboard and un hook the plumbing and bring it to your local pool pump motor repair guy and have him test it. it just

...of the pump) Unless there is a normally closed and a normally open spade connection? is this a mechanical spa control system, or is it a digital electronic, with a circuitboard, spa control