I have it pair to my I phone ----but I lost my manual what are the buttons for?

When device is in pairing mode (device on, long press "talk" button until LED is steady blue), long press the "up" button until the LED blinks twice.
Then search it on the second phone and pair it.
Turn HS off, then on.

Hello,

Thanks for using Supertooth.


1. From OFF, press and hold the Accept Button (green button).

2. While holding the Accept Button , switch the kit on (Press-and-release
the

Microphone Shaft ).

3. When the Bluetooth Indicator turns blinking red/blue, release the

Accept Button. The kit is now in pairing mode.



4. While the kit is in pairing mode, access the Bluetooth menu of your
phone.

Turn on the Bluetooth function then execute a Bluetooth search, or discover.

(See your phone's manual.)

5. When the phone displays the list of Bluetooth devices, select ST LIGHT.

6. When the phone asks for the password, enter 0000 and press Ok.

The kit is now ready to use.

Best regards

SUPERTOOTH

hold all three buttons together ie power and volume ,three color lights will blink, this resets the jabra headset, then try pairing again , when pairing the lights should not slow blink. it should stay constant or random flashing.

You can download the manual from the proprietry website (http://www.farant.com/bck08a_manual.html ) but essentialy press and hold the multifunction (on/off) button till it flashes blue and red alternatively. It tells you what to do from there.

Factory Setting is usually 0000. In order to pair with your mobile (Max 8 phones), Depress green button on ST ONE R57 for 5 seconds approx. Light will flash red & blue, indicating that device is in pairing mode. Phone should have "Bluetooth" switched on (in settings) and search mode activated. Good luck

close the mic and hold down the button until it becomes purple. Open the mic and it should stay steady lit purple. Then you can pair it with your phone. I found the manual online because I had lost mine as well. Also, make sure any old phone you were using it with is off so it does not connect with that one. Good luck!

To put the Drivespeech into pairing mode - with power OFF, press the power on button until the Drivespeech powers on and CONTINUE to hold the button until it announces it is in pairing mode and the LED flashes alternate Red/Blue.
Select 'Discover' on your phones Bluetooth menu and enter the code when requested (usually 0000 or 1234)
HTH

Hi, to pair this device first make sure it is powered off.
Then press and keep holding the power on button (large round one on the front). After a few seconds the LED will illuminate blue and then after a couple more seconds will flash red and blue. Now you should be able to pair with it.
Regards,
Nik.

Since it was already paired with your cell phone it should show up in your phones bluetooth device list, it should be as easy as navigating to the bluetooth settings in your phone (usually found in tools) and selecting the Voyager 520 and selecting the connect button. Give it a try as I have to reconnect mine periodically also.

Solution #2 posted on Aug 24, 2008

Guest
Rank: Apprentice
Rating: 0%, 0 votes
Pair Your Headset
Before using, you must pair your headset.
1. Turn phone on.
2. With Headset off, push Talk/Volume up button for 10 seconds. Blue LED will flash rapidly.
3. Follow pairing instructions in phone-setup or connect menu. Your phone should find “Logitech
HS04VXX”Headset and prompt you for a passkey pin.
4. Enter “0000”.
5. Press OK on phone.
6. From Headset device list press “Logitech HS04VXX” Headset.
7. Select connect.
When your Headset is successfully paired, the blue LED will flash slowly.