Problem with copier Rex Rotary DSc232

see here http://copiers-orange-county.com/afficio-error-sc542/

This a fuser (hot section) error code that need you to enter service mode to clear, -Carl

fuser problem. Call for service

That is a "Laser motor" Error - Laser motor is dead, and needs replacement.

please precise which is the brand and model
by the code it seems to be a ricoh,nashuatec,lanier,infotec,rex-rotary,gestetner
but you have to specify the model

Hello wajidsn

SC548 : "Fusing Installation Error.Fusing Unit Set Error"

Enter SP 5-810 and set to 1, then switch off and on the machine.

you have to go into the sp modes to clear this code .pres the yellow c then 107 and hold down the orange c , do this all in sequence , it wil go in the sp modes and show copy sp .enter there and switch the power off wait 5 seconds switch back on

Hello velin viv,
The copier does not see the proper operation of the transfer belt. This is a film belt that is part of the development of the image and transfer of the image to the paper. Its critical movement is monitored. SC 481 means that either the belt is not moving, or the sensor that monitors the belts movement is bad,or the belt has torn and is physically unable to be monitored, or (save the best for last) the main controller has lost its mind and does not recognize the inputs it is given. I wish I could help you further. Typically the belt is torn, from simple wear.

This means the fuser has an error. You can not reset the code even if the fault has passed without entering the service mode. If you need a service manual for this let me know and I will send you a link.