Model gwl 15 us not draining - Fisher and Paykel Fisher & Paykel Washer

A short circuit in the motor is the most likely reason. You need a service engineer to correctly diagnose.

they have a speed sensor at the bottom on side of motor if faulty it wont let motor spin up. sometimes it can be a computer panel issue .
if machine does the check lights and beep ok likely it is sensor

Your motor controller board needs three 332k resistors replaced to make it spin again,Only on Series 11 Models

I cannot find your mothers IWL16 model, but I have found various similar machines that are the same phase as your GWL11 machine, the electronics in there although different are compatible, you can swap the drain pumps, there almost universal, avoid the drive shaft machine, fix the other one If you want further help, post a photo of both pcb's (the electronics) After swapping your machine will stil require programming which is simple enough

normally thats a bad door safety switch,, bypass it with a Jumper wire , if it works with the jumper, replace the switch

Could be something in the pump. The pump is on the bottom of the tub.
It has a locking tab which you release and then twist the pump a hair and it will fall out. Warning: Have rags ready! I have the original GWL service manual and the GWL 11 supplimental manual. Let me know if you want them.


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

maybe blocked drain pump can u hear a buzzing when it tries to drain water

A washer cannot pump the water out too fast, regardless of what you have done or have been told, the problem is too do do with the drain outlet, I suggest you completely take apart the stand pipe and any other pipes connected, and thouroughly clean them .
Please rate my solution.
Thanks.

The very same thing happened to me just a week ago. The main board was fried. $168.00 worth. Good luck. Mark E.

NEED TO KNOW WHERE YOU ARE LOCATED. WE ARE AN AUTHORIZED SERVICER AND CAN OBTAIN PARTS FOR YOU.