The coil in my oven caught on fire

Because it failed

Ask an appliance parts store how
many times they see that

which engine, they work different.
you saw gas where.?
you saw fuel where??
you saw something turn, what?
try this.
it cranks robustly (250RPM = robust)?
the engines cranks over, (i see pulley spin fast on crank)?
the engine fails to start and to RUN (sustained).?
you lost spark to 4 or 6 clingers, all are dead spark?
so you place the diagnostic jumper wire and crank for
5seconds
and release the key,
got DTC error codes, bingo.
if not bad spark is bad coil or bad ignitor that drives said coil.

next is fueling but above is all first.
fuel is always LAST. (ECU cuts fuel for many reasons) ask.

what's the full model number?

Hi,
Yes the broiler will often turn on to help preheat the oven.
If it caught fire, it is not because of that, but because you have too much run over food in the oven. That is what caught fire. You need to clean it an NOT with the self clean!!

hetaman101

Kill the power to the stove. L2 is always hot to the element. If it welded itself to the frame whats left of the element stays hot. Easy fix but power needs to be OFF

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

F3 usually means, that the oven temp. sensor is bad and one need to replace it.
The fact, that it's not heating tells me, the fuse in the back also needs to be replaced (requires pulling out).

Whirlpool oven repair orange county, ca

you need to replace that element ASAP. It is shot

no its not you will needed some one to look at this to see if it can be repaired or can you claim for a new one on house insurance as it caught fire

Put the oven back into a clean cycle, when finished the door should unlock.

just scrape out the residue and clean it again.