My phone line has no dial tone and in the base set i have a"line in use" message. When I call from any phone to my house it rings forever without any response
I've had the same problem for the last couple of days. The base says line in use, no dial tone and if you call my number it just rings. I tested the line outside, and that is fine. Also, it will start working all of a sudden, be OK for a while, and then go out again. No rhyme or reason. Any ideas would be greatly appreciated.
When I dial 0 from panasonic Kxt7730 it says resticted. How can I dial zero from this
There's a short circuit insideon your telephone, an electrical dc could be that make the unit not working.
Take a look at the buttom part of the telephone, i know there's a switch like LP & DP mode.
Oh.. I think and maybe you also think this, there's no problem on your unit, i guess the problem is on the line. It is a better option for you to call your Telephone Network Provider to make a test on the line, some calibration from them with the line will fix the problem.
Thanks,
×
The wire that is used to connect the line to the telephone is not proper...
i guess the problem is on the line. It is a better option for you to
call your Telephone Network Provider to make a test on the line, some
calibration from them with the line will fix the problem.
Here at FixYa, we love to get FixYa ratings for offering great advice
for your problem in our attempts to help you the client with your
problem.
If you think I am deserving, A FixYa rating would be greatly appreciated.
kind regards
sweet rascal
wow thats great.
i said you right.." wire that is used to connect the line to the telephone is not proper"... tat is what i said in my first post..
cool..
good day..
thank you
dont forget to rate the solution.
×
SOURCE: no dial tone and "line in use " message
Try the simple things first. Try a different phone. In my case, I had the phone company check - outside was fine. After two hours my phone worked. I figured out what happened in my case. Both phones were dead (battery). I think one died with the phone off the hook. once the phones were fully charged, the phone worked.
656 views
Usually answered in minutes!
I've tried plugging different phones into the jacks, but still no dial tone.
If you are talking about the wire from the jack to the phone, I've tried different phones with different wires and still no luck. As I stated, at times it will start working for a while (for example, it worked all day yesterday, until this morning when it just went out again).
Found the problem. It was a cracked wire from the junktion box to the house. A little splicing fixed it right up.
Thanks.
i changed my line rental the the phone isnt working. there is not dial tone and calls cannot be made
LINES ON EXTENSIONS ARE LIT ON ALL PHONES BUT CAN'T GET DIAL TONE ON THE LIT LINES
The phones suddenly stopped working. Made some strange ringing tones when receiving calls prior. All 4 units stopped working. It is not the phone line
×