Very noisy on spin cycle only

LG Washer & Dryer 7 (WD12331AD)
Its is a direct drive front loader with 7kg capacity for washing and 3.5kg capacity for drying.

when new
thats 7 kg with wet clothes and water
and only 3.5 kg wet clothes to dry

the older it gets the less weight it can wash and dry

worn motor or drum overload if it doesnt want to spin at all

leak at the door . replace the door seal ..is a most common fix

extra info
It has 9 preset settings, 400 - 1200 RPM, 5 temperature settings, digital display and delayed start timer.

hi try tilting it back put a basin below the front filter door then check that the filter is clear

bearings v suspect

Check to see if the drain pump or drain pump filter are clogged. Sometimes objects that are put into the washing machine, for example combs, money, hair pins, etc. end up in the filter. Finally, if the drain line is clear and the pump seems to be clear and functioning properly, you may need to replace the drain pump assembly.
The most common problem with spinning on this model machine is the tub bearing. Normally it would be very noisy when it did spin.
Massive job to replace it.

Check in the user manual that you are using the correct compartment for the softener. On LG machines it is normally the middle compartment.

K this is a very complex job because it sounds like you may have coins (money) that has fallen between the gap. If this is the case, then the only way is to open up the back panel and look for it. However, I would not recommend doing it as the warranty will be void if you do. Now the stupid thing about this is a service tech will charge if it is coins lol. If it\'s the machine itself then it will be free provided it is still under warranty. Good luck!

sounds like damper rods are getting worn. they support bowl underneath.i think if u change them it should fix problem. is it noisy during spin?if u need more help please reply. please turn power off b4 working on it do not want any accidents.

Remove drum drive belt, and spin drum by hand, if there is any resistance,. or it feels rough or noisy, the the main bearigs have probably failed.
If it is o/k then check motor for worn or noisy bearings,
Please rate my solution.
Thanks.

you will have to access the bottom of the agitator from the back of the machine. Either you have loose bolts or else you agitator bearings are shot

if its a direct drive remove the rotor and see if theres a loose magnet etc,hope this helps