Model 2515. How can I replace 'Paper In' sensor?

To know how to reset HP 2515 printer to factory settings, follow the steps appropriately mentioned. Firstly, if the HP 2515 printer is turned on, disconnect the power cord from the printer. After this, unplug the power cord from the wall outlet. After that, wait for 15 to 20 seconds and plug the power cord back into the wall outlet. Here, reconnect the power cord to the printer and turn on your HP 2515 printer. With this, your printer is back to its factory default settings.

https://www.youtube.com/watch?v=sEQ_ZIEG4vw

that is a vid for the brushes..........just search then on same page for disassemble .

cheers

Check it again, maybe a ting piece of paper is triggering the jam error.

re install soft ware

To get the user manual/support/information for your 2515, go here:

https://support.hp.com/us-en/product/hp-deskjet-ink-advantage-2510-all-in-one-printer-series/5165417/model/5165418/manuals

I am assuming that the manual will explain the error codes, what they mean, and how to deal with them.

Good luck.

Hello,

May i know the printer model # / name ( full ) to assist you better. ?

Remove jammed paper carefully and turn back on.

I had one today with a toner low light with new toner installed. Turns out they broke the green cartridge retainer clip.
The toner sensor pn# 130K45680 btw.
let us know if it was the sensor.

Paper goes on the bottom first. original goes in top next

the first step is to pull the paper out and see if the feed rollers have left a mark on the paper that would mean your rollers are turning just not picking up the paper if this is the case remove the paper tray and with a wet rag clean the feed rollers always easier with a flash light keep in mind they may need to be replaced call 7734748865 il b happy to help