Sir I have xerox 5755 copier. My power supply faulty for r3 temperature fault so how to repair power supply please give suggestions

This fault is coming on my copier 5755 what is the solution

http://www.usask.ca/consumer_services/officecopiers/Replace_Fuser_Module_and_Ozone_Filter.pdf

if you have replaced the ozone filter also, ignore.
if not, shut down.

give me answer please

Can you feel any physical heat from the fuser. Sounds like either the thermistor that controls temperature or the lamp failed.

Kindly provide solution of wavy print in xerox 5755.
Whatsapp 00923334298796

55 PPM

From the service manual:

37,002.4x - PEST_FAULT_JSL_HEATER_DISCONNECT
PEST - Left jetstack disconnect.The left jetstack is not drawing the expected power from
the supply.
1. Run the printhead Left Jetstack Heater test.
2. Verify printhead wiring.

Yes, could be faulty printhead, but could be faulty power supply as well.

I have the full service manual available if you need it. Please take a moment to give this solution a rating of fixya. Thanks!

From the Xerox Solution center --

Solutions for : Fault Codes 13,XXX.4X: Thermal Error Related Fault Codes: 13,xxx.4x Solutions ranked by relevance:

1. Make Sure the Room Temperature is Within Operating Temperature Specifications
2. Make Sure the Power Source is Not Causing the Behavior

A previous firm I worked at had these units. Do not plug them into a surge protector of backup power supply system.

From the service manual:

37,002.4x - PEST_FAULT_JSL_HEATER_DISCONNECT
PEST - Left jetstack disconnect.The left jetstack is not drawing the expected power from
the supply.
1. Run the printhead Left Jetstack Heater test.
2. Verify printhead wiring.

Yes, could be faulty printhead, but could be faulty power supply as well.

I have the full service manual available if you need it. Please take a moment to give this solution a rating of fixya. Thanks!