I NEED a technical Reference Manual with schematic to show me how to assemble a tiller from a pride legend XL (SC3450).

Try a local auto transmission rebuild company.

Or, here for your parts

https://www.google.com/search?q=pride+DRVASMB1627

Motor transaxle and brake is here
https://www.monsterscooterparts.com/brands/pride/models/legend-xl/motor-assembly-motor-transaxle-and-brake-for-the-pride-legend-xl-sc3450.html

More here

https://www.google.com/search?q=pride+DRVASMB1610

..

On the XL the adjustment is on the tiller handlebars. The left hand bar has a pull lever like a small brake lever. This is the release for the tilt on the tiller.


https://www.pridemobility.com/pdf/owners_manuals/us_scooter/us_pursuit_xl_om.pdf

go google and type in ---workshop manual for pride legend xl scooter --and if there is a pdf version , download it
if not contact the manufacturer direct and see if you can buy one

That is the same problem I had on my Pride Legend Xl. I bought
used. Tiller mechanism switch and cable would not lock the mechanism down below. I tried a few things to just lock it in the upright position permanently, finally I discovered the only way to "lock" the tiller, was to use a huge automotive 3-6 inch diameter
hose clamp, and install it inside the rubber boot at the bottom of the tiller to tighten around the tiller tilt mechanism and prevent it from
tilting, and that has worked for me. The lock mechanisms seem to be prone to failure on some models and the cost of repairing them is very expensive.

hi, please check the fuses on the tiller stem ?

regards

I had a similar problem with my Pride Legend XL when I drove it
through a puddle accidently and some water splashed up underneath
the motor controller. It would buck or go then stoo without any warning
as the electric brake was applied. Had to take the seat off and use a
hair dryer on the controller connections to dry them out. It doesn't
seem to take much water to make these inoperative. After thoroughly
dried out with a hair dryer..no more problems like that with it.

I have downloaded a service manual for your scooter on this site.

You can e-mail me and I can send you a copy.

[email protected]

hi i hsave a pride legend classic mobility scooter it will run ok for a few yards then suddenly stop but if u wait for a bit it will go again whats the problem thanks

My Pride Colt XL8 keeped cutting out (7 flashes of LED, Speed pot error) , checked all the cable connections up tiller arm as recommended by Pride technical support, worked for about a week, then problem returned. Eventually took to Pride dealer, with problem occasional occurring,they found it to be the lower tiller cable support bracket straining the cables connector intermittently and so removed the bracket, the problem then was solved !

Hi ,you need to check whether there are any fuses under the seat,

Does the horn work ? , do the power tiller ? the display showing how much the battery is charged

Regards
GeWiz