Water streams from panarello and coffee spouts when making a coffee

If the water pressure coming out of the steam/hot water arm is fine, then the issue is likely with the brew unit or the grinder. Here are a few things you can check:

1. Clean the brew unit: A dirty or clogged brew unit can slow down the flow of water. Remove the brew unit and clean it thoroughly, making sure to remove any coffee residue or buildup.
2. Check the grinder: A dull or clogged grinder can also slow down the flow of water. Make sure the grinder is set to the appropriate setting for your coffee beans and check that the grinder is not clogged.
3. Check the water flow meter: The water flow meter measures the amount of water flowing through the machine. If it is clogged or damaged, it can affect the flow of water. Try cleaning the water flow meter with a soft-bristled brush and see if that helps.
4. Check the water filter: If your machine has a water filter, it may be clogged and affecting the flow of water. Replace the filter if necessary.

If none of these solutions help, it may be a more serious issue and you may need to bring your machine to a professional for repair.

Clean the port using a small paper clip. Push it up the tube and pop out the material that collected inside.
Always use Distillate or Filtered water.

Making froth with a steam wand is an entire technique. Also depends if it has a panarello or not

If you don't have a manual I hope this helps. You can make coffee without "Descale"ing it but it is recommended you don't go too long without doing it.

- Make sure that the filled water container is in the appliance.

- Turn the program selector to "On" with lighting and place a container under the hot water spout and another under the steam spout.

- Press the hot water button, turn the steam selector counterclockwise and dispense hot water until it flows in quiet, continuous streams.

- Press the hot water button again. Turn the steam selector clockwise to o, to turn off the water.

Regards,

Dave - Avalonxls at att dot net

call 07779933829 we repair

I find that the panarello on the Vienna oveer-froths the milk and makes too many large bubbles as opposed to the preferred micro bubbles. The Gaggia Panarello Replacement Wands will work as a better replacement and the stainless steel one makes much better foam. I found Seattle Coffee Gear sells them for a reasonable price, $40 for the Stainless, and $20 for the plastic:

http://www.seattlecoffeegear.com/SearchResults.asp

I had this problem and the spout was blocked you can push a small wire through the hole in the midle of the large white spout

- Make sure that the filled water container is in the appliance.

- Turn the program selector to "On" with lighting and place a container under the hot water spout and another

under the steam spout.

- Press the hot water button, turn the steam selector counterclockwise and dispense hot water until it flows in

quiet, continuous streams.

- Press the hot water button again.

Turn the steam selector clockwise to o, to turn off the water.

If this doesn't do it for you, you are doing it wrong!

run vineger through it or CLR before they plug up completly. good luck

easiest solution is to replace the steam valve.