I've got a problem with my machine it's not heating up water

thermostat or heating heating element failed

in the back of the machine attached to the bowl is a small tube that goes up to the controller in the dash panel. This tube should be straight with no kinks or pinch points. This is pitote tube and conveys pressure to the controller diaphragm that connects to a micro switch that turns the water off and the machine on. As the water rises the air trapped in the tube increases in pressure and pushes on the diaphragm. Sometimes if there is water trapped in the tube it stops working You control the pressure that the diaphragm works at by the water level you select

The timer circuit on the panel needs to be replaced. It is not going through all of the cycles!

I would check the motor. Sound like it may be at fault.

Steam presses are fairly simple machines. You have a boiler and steam ports. First if you've been using tap water, you probably have a build up of minerals and eventually killed the heating element.

Get a new one.

is the tap turned on?

Contact a qualified heating engineer,they will sort it properly.

You need to check the heating element continuity using a multimeter. If there is continuity then check voltage at the time of the heating , if there is no voltage then the control panel is a suspect including the relay to the coil.

You are out of water!!!! The blue light is for the water tank.

it will work fine but the problem is that all the rinses will be done with warm water, this causes seriously wrinkled washing thats v hard to iron out.