How do you load a 66 power master .177 Cal BB gun

As long as the diameter of the shot is the same. I had a Daisy when I was a kid I shot spaghetti out of it.

Depends on the rifle/pistol. If it\'s a bb Rifle, often times there is a screw cap that you remove and put your rounds into and reinstall the cap. Some are break action and you load them one at a time. Knowing which weapon you are working with would help identify how you load it.

Life sucks. Take it to a gunsmith or send it back to the factory for re-assembly.

most dont i have one but pull down the barrel and put a bb in it then pull it back up take saftey off then u should be able to shoot

yes it safe to shoot bb,s in the 1377 pump pistol,i have 3 of them they actually shoot true'er and with more vilocity

Time to buy a new model. I had 2 of those with similar problems and couldn't find parts. Try the CO2 model 1088. I'm happy with mine. Spray the seals with silicone spray monthly or every 2 cartridges.

Are you sure its a bb gun and not a pellet gun? Usually bb guns have a magnet on the bolt, that keep the bbs from falling out. Pellets don't roll so the won't roll out the barrell.

TRY PUTTING A LITTLE OIL ON THE SEAL ON THE PUMP LEVER . OPEN THE PUMP HANDLE COMPLETLY YOU SHOULD SEE A SEAL THATS WHAT YOU OIL.

66
C66-OM
C66-EVP & PL 1 & 2 Powermaster. Pneumatic, BB repeater, .177 cal., single shot pellet. First variant w/zinc receiver. 1983-1988 Some parts are available. 66
C66-OM
C66-EVP Powermaster. Pneumatic, BB repeater, .177 cal., single shot pellet. Plastic receiver. 1988-2001 Some parts are available. 66
C66CLIP-OM
C66CLIP-EVP Powermaster. Pneumatic, BB repeater, .177 cal., single shot pellet. Plastic receiver and 5 shot manual clip. 2001-Present Some parts are available
HERE IS MANUALS I FOUND..HOPE THIS HELPS..