Looking for ignition parts for 920 jonsered chainsaw

get it here
www.lilredbarn.net > PARTS > Chainsaws > Jonsered > Jonsered 2050 Turbo
or here
www.ebay.com > ... > Jonsered Chainsaw Pistons&Cylinder Kits

Ian Duncan...

I have no idea if you are bragging or complaining...

I WILL TELL YOU ... I have started many many a chain saw... and the chokes are nearly useless...

FIRST RULE: always use only fresh fuel...!!

Proper sequence for an ice cold saw (optimal adjustment)...
- squish the fuel bulb a couple of times
- set the choke
- couple of yanks until it coughs...
- completely release the choke and the next yank will get you running

If you have NO CHOKE... JUST leave the THROTTLE ALONE
until it coughs... Then start juicing the throttle...

What's a jonstred? Oh... Jonsered

62results for choke jonsered

Jonsered Chainsaw Parts Chainsaw Parts Discount Online Parts

the sprocket is part of the centrifugal clutch assembly
go google and type in ---workshop manual for jonsered chain saws and there are pages of manuals
I opened one page named jonsered 2036 workshop manual --pdf download and it shows how to work on the chainsaw and includes other models in the procedures
that site is www.manualslib.com>brands>jonsered manuals> chainsaws>2036

http://www.ebay.co.uk/sch/i.html?_nkw=jonsered+chainsaw+parts

http://www.centralspares.co.uk/brand-group/jonsered.aspx

http://www.ebay.com/sch/i.html?_nkw=jonsered+520sp

basic settings for this saw would be one turn out on both screws, these are base settings so fine adjustment would have to be done, it it will not run at these settings there is somthing else wrong with it.

My suggestion is to find a good lawn and garden shop that repairs chainsaws. Take the saw there and they should have parts. If the shop is a Jonsered dealer your chances are better. I would start with the yellow pages under SAWS.

Husqvarna never used this model in there range, they used the same cylinder,piston and crank assembly in the 41/141 but all other components were different to the Jonsered, the part no. for the Jonsered top handle is 530038327

The hand guard is secured on the left side with the top l/h starter cover screw part no. 503203419, the right side is held to the brake actuating arm with a 4mm screw part no. 503202512.
Let me know if you need other parts.

A typical fuel system and a couple of tips:
http://www.fixya.com/support/r3706813-2_cycle_fuel_system_repair

The IPL (exploded parts list) for your saw is the only detail for fuel line routing and it is sketchy at best; components are listed but may be on different illustrations.
IPL courtesy of "gridserver.com" (may not be your saw) You can download an Operators Manual at Jonsered.com but no IPLs.
http://s30387.gridserver.com/partsDiagrams/Jonsered%202041%202045%202050.pdf
Husqvarna is the parent company. I would try a local Husky dealer for parts if JRed dealer close. It often saves shipping cost.
HTH
Lou

Hi,
Here is a link or two with phone numbers that might lead you to a replacement part for your saw.
This site is for used parts... might be cheaper:
http://store.chainsawr.com/products/jonsered-2050-turbo-chainsaw-flywheel-cover-shroud
http://www.nitrolawnmower.com/nitro_lawnmower_024.htm

Hope this helps... Good luck!