Konica 3135 shows error code p51; front door is closed but the code will not reset
SOURCE: Konica 3135 Copier Code F 36
Well, I'm sorry to say that you're going to need a tech for this problem. You have a fuser problem...either a blown fuse, heater lamp, thermistor, or something...whatever the cause, the fuser is not heating up. And the code can only be reset within service mode, once the problem is repaired.
SOURCE: Error message 45-1 is being display on Konica
most often what i have seen the cause of this problem is the lens motor pulley gets a crack in it which causes the pulley not to turn when the motor turns i have had some luck with pulling the pulley off the shaft and putting a drop of super glue on it then put it back on the shaft and it will hold for a while but the bad news is they dont make parts for this machine anymore so the time is near for this machine to be replaced sorry
SOURCE: How do you fix a F 86 error code on a konica 3135
This error code not exist .Please tell me precise your problems and your error code.
SOURCE: konica 7040 error code F-34-3
Friend, this code refers to short-circuit the corona separation and transfer, check for accumulation of toner and do a cleanup in the corona.
217 views
Usually answered in minutes!
×