Where can i get a 110 power reducer for a Regency turbo scan 800 scanner

SOURCE: regency scanner r1070 error message fr err, will not scan

I'm assuming you know already, but just in case you don't. You need to be scanning in supported ranges, those are:

30-50 Mhz
144-174
440-512

SOURCE: Scanner will not scan the 800 band

You didn't mention your location or the type(s) of digital system signals you lost, but if you've been listening to an EDACS system it's possible that the manager has switched on the PROVOICE security option. That would prevent your scanners from recognizing the effected users and would also account for both scanners being effected. If your area is using EDACS I suggest that you visit www.RadioReference.com to check on system particulars.

The PRO-95 is also known for losing its logic and requiring a RESET or INITIALIZE, although it would odd for two units to go squirrelly at the same time.

If all else fails, you can RESET or INITIALIZE the scanners to bring them back to normal operation.

To RESET:
- Power the scanner OFF
- Power the scanner back ON
- Insert a pointed object (paper clip, penpoint, etc.) into the RESET hole on the back of the scanner
- Gently press and then release the RESET button inside the hole.

NOTE: RESET will NOT erase the data that you've programmed into the scanner.

If RESET doesn't clear the problem, you can carry out the more drastic INITIALIZE process.

- Power the scanner OFF
- Power the scanner back ON
- Press 0 then 1 while "Welcome to Dual Trunking" is displayed.
- "Initializing Please Wait" will appear for about 2 seconds.

DO NOT power the scanner OFF until the INITIALIZE process is complete (M000 and Bank 0 Ch 00 appear on the display). The INITIALIZE procedure will reset the scanner to original factory settings and erase all data that you have programmed.

BillB