<!-- from fixya rte -->Why am I loosing the top of my page? - Microsoft Windows 98 for PC

CRT base card socket fault. Loose solder terminals or internal loose contact. Replace it and then check. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/ Type in this key phrase " my service table today " in the search box at the top right of the the home page, to get gathered some pages which has the details of practical experiences of the author of that site.

Hi CynhiaThis is a very basic question. ~Bookmark you lyrtics page and you will never loose it. If you are using Safari, Google is on every single web[age you open - Top right corner.

This is a problem with thread tension. The needle thread is too tight and the bobbin thread is too loose. I don't have one of these machines, but there should be either screws or knobs to adjust. Look at your manual. Here's a page I found on bobbin tension.
https://www.manualslib.com/manual/1022927/Toyota-Quilt-50.html?page=50

There is a comprehensive 5 page illustrated tutorial I have written to address this specific issue: HERE

Inspect the rotor position sensor for loose or frayed wires. The washer tub and motor are all suspended on 4 rods. See page 59
More about the rotor position sensor is on page 57 of your service manual.

Whirlpool Cabrio Washer with 6th Sense Technology.pdf
Google Docs. 16 megs. Printable version.

Was this helpful?


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Usually If the underneath is loose it is the top tension that is the problem. If it is the top stitching that is loose it is the bottom tension. Hope this helps.

If the bottom is vertically split, then there could be some problem in the hardware (bottom scanning module) Check for loose contacts. If it is cut horizontally, it must be definitely loose contat problem.
S. Mohan, India

the reason why i ask that because if the fold looks like its been pressed then its before the fuser but if its loose than its after. And thats how we can determine where it begins

Are you sure you have the belt routed correctly? You can verify by going to repairclinic.com and clicking on the "Repair Help" link at the top of the page. On the following page is a link entitled "Dryer Belt Diagrams" under the "Special Features" section. You will need to view diagram E for Maytag. NOTE: There is a tension spring on your idler. Make sure the tension spring has not come loose or fallen off. I hope this helps you. If you have questions, please let me know.

Is there a gear grinding noise associated with this? If so, call your local dealer for service. If not:Clean all the rollers you can reach with a cloth dampened with alcohol. Check for any obstructions in the paper path like torn paper, heavy toner buildup on guide plates or the edges of the scanning glass, or any paper guides obviously loose or out of place.