Electrolux screaching noise on spin cycle

Contact a washer repairman.

An A/C clutch will not make this concern happen, more likely the A/C compressor is begining to go out. The belt on the A/C clutch Assy. free wheels (spins feree on the pulley) when clutch is not engaged. If concern is not present with A/C off this means the bearings in the puley assy. ok. Once the A/C clutch is engaged it locks the compressor against the spinning pulley and turn the compressor chaft and spins the A/C compressor internal shaft. If you hear a loud "screach" when you turn on the A/C it means the belt slipped for a second, if it continiues to screach it means either the belt is loose or that the compressor is internaly locking up. I wouild start by checking the belt tension (if not equipted with and auto tensioner). You can also remove the belt and turn on the A/C and attempt to turn the clutch/pulley by hand, it should turn with a little effect but should not bind or lock at times if that happens compressor is bad.

check the drive belt from the motor to the gearbox it might be louse that would make it screach and week agitating

Sounds like a transmission problem. Not worth the repair judging from age.

probably needs a new belt,water gets on it and makes it squeal

You either have something caught between the tub and basket or a bearing bad.
Eric

Its a bearing on its way out. the seal is also probably worn.

Good morning! Possibly the noise was due to improper placement of load into the spinner which should be within its capacity load. best regards.

I have the same problem...during SPIN it make a LOUD SCREECHING sound.

is the bottom foam shipping base still on the washer