Belt on my nortic treadmill is not engaging - Nordic Track NordicTrack T9 ci Treadmill

It seems like you're experiencing issues with your Pro-Form 580X treadmill. Here are some troubleshooting steps you can try:

Safety Key: Ensure that the safety key is properly inserted into the console. Treadmills typically have a magnetic safety key that must be in place for the treadmill to operate.

Circuit Breaker: Check if there's a circuit breaker on the treadmill. If it has tripped, reset it. This is often located near the power cord entry point.

Power Source: Verify that the treadmill is properly plugged into a functioning power outlet. Test the outlet with another device to make sure it's working.

Calibration: Some treadmills require periodic calibration. Check the user manual for instructions on how to calibrate your specific model.

Check for Obstructions: Ensure that there are no obstructions or debris around the belt or underneath the treadmill that might be preventing it from moving.

Lubrication: Treadmill belts may require lubrication. Consult your user manual for guidance on how to lubricate the belt properly.

Control Panel: If the control panel buttons are not responding, it could indicate an issue with the console or wiring. You may need to contact Pro-Form customer support or a technician for further assistance.

If none of these steps resolve the issue, it's advisable to reach out to Pro-Form customer support or a qualified technician for a more thorough diagnosis and potential repairs.

If you wish to get some details; check the site linked here. Pull up older posts...
http://electro-medical.blogspot.com/

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH

The following link is to a manual for your model. This should provide some insight before disassembling the unit. The most important part is to label the connection wires so that you are sure where they go when you put it back together. Also be considerate of any pinch points so that you do not accidentally pinch or crimp any wires when putting it back together.

249920 NORDICTRACK 1500 TREADMILL SPORTSMITH net

Check for new batteries, back or bottom on the display.

Unplug it completely, and wait a couple of mins, try again, if still no response you may have a main circuit board fault.

Step 1:

please see the video and diagram attached. God bless you

Step 2:

Step 3:

Unplug the unit and remove the motor shroud insert plug back in the outlet.The single most cause of no motor output is failure of the DC motor control. Look for any test lights on the power boards beneath the motor hood.If it operates on an open-loop system, the computer will run normally and not give and error code, but the motor will not turn. If you have a multimeter, you can test to make sure you have DC output from the controller spades if not replace the control board. If you have DC output, but motor is not turning the test the motor itself.
Cordless drill battery- get a fully-charged, 18 volt (preferred) cordless drill battery and on most treadmills connect the red and black motor leads to the battery (some have different colors but if you have two wires and get it hooked up backwards, the motor will just run backwards and won’t be harmed). If good, the motor should operate at about 1 MPH.
Car battery- these are 12VDC high amp batteries so the motor will turn slowly but you can walk on the belt. Always be careful with battery acid on these things so we don’t recommend bringing them in the house…take the treadmill to the battery.
Lantern battery- a fully charged lantern battery should operate your motor at a slow speed but lacks the amperage to have someone walk on the belt. If it does not rotate replace motor

Check speed sensor and make sure belt is lubricated. If this two are fine than motor control board may need to be repaired or replaced.

You need to have the power supply board rebuilt with larger Caps and resistors. Look on the internet under treadmill repairs. The board is easy to replace yourself so don't have someone come in and overcharge you. I think about 4 screws and two plugs.

change drive belt proform xp 550s treadmill