BATTERY NEED NEW BATTERY

think you need to clean up some contacts

its like 7 dollars just get a new one if its clicking it might need a new battery i got one of the new gel batteries ,if bat is good it probly needs a new solenoid

If just the screen is non-fuction, you need a iPad replacemebnt repair parts

Open the system, unplug the transformer, disconnect one lead of your battery, reconnect the battery first, then the Ac if it says low battery still, then you need a new battery take the one you have go to battery plus get a new one, and reconnect it, it may still say low battery, wait for an hour for the battery to charge, disconnect the AC and battery again, reconnect the battery first then the transformer. It should clear the low battery.That battery is a
6 VDC 1,.9 Ah.

Hi,

This sounds like the laptop is faulty if within minutes the laptop is totally drained of power from a so-called full charge.
Because the laptop is new then I recommend that you send or take the laptop back for repair or replacement as it's still covered by the manufacturers warranty.




Regards.

disconnect battery put dc meter on wires. should read over 6v if not need new panel. if over 6v put system in sensor test wait 5min then close cover hit status 2 times. if reset great. if not try another battery. repeat sensor test. if resets great if not need new panel. : (

WHEN YOU REPLACE BATTERY.MAKE SURE NEW BATTERY HAS THE SAME COLD CRANKING AMPS OLD BATTERY HAS.IF YOU NOT SURE YOUR OWNERS MANUAL WILL TELL YOU OR THE AUTO PARTS PLACE WILL FIND WHAT YOU NEED.BUT IF THAT YOUR ORIGINAL BATTERY LOOK ON TOP OR SIDES.YOU WILL SEE WHAT CCAMPS YOU NEED.TURN OFF RADIO BEFORE DISCONNECTING BATTERY SO YOU WONT LOSE CODE.

It's battery. That's usually a low battery alarm. You need a new battery and possibly the internal software reset. You need an RBC6, check shopping sites, figure $80 for low end.

I install these panels.  For the low battery message to clear you need to power the system down completely.  To do this you need to unplug the battery and also unplug the transformer plugged into an electrical outlet.  When you power the system back up, you need to first plug in the battery leads.  Then the transformer.  

Sounds like you need a new battery.

Hope that helped...

Geno