Fisher and paykel WL80T65D stops at spin cycle red spanner light flashes lights 1(regular) and 7 (easy iron) lights are on

It sounds like your Fisher and Paykel washing machine is displaying an error code, indicated by the beeping sound, the blinking wrench light, and the Regular and Easy Iron lights being on. The specific meaning of this error code will vary depending on the model of your washing machine, but it likely indicates a problem with the water supply.
The most likely cause of the problem is a clogged inlet hose or inlet valve. The hose that connects the water supply to the washing machine can become clogged with debris, and the inlet valve can become clogged with mineral buildup. To fix this problem, check the inlet hose and valve for any clogs or debris.
Another possible cause could be a malfunctioning pressure switch, which measures the water level in the machine. It could malfunction, causing the device to think that the water level is too low and stopping it from flowing in.
You should consult your washing machine's user manual for the specific error code and troubleshooting steps for your model or contact the manufacturer for further assistance.
It's essential to follow the manufacturer's instructions and guidelines when working on your washing machine and only attempt to repair or service it yourself if you are familiar with the product.

tub not level id top loader
indicates the tub support eods have failed air dampeners at the bottom ends and the tub is not level

Hotpoint, GE, RCA Washer Repair - Does not spin or drain ...

? 6:13
https://www.youtube.com/watch?v=69az-ZA3eSQ
Jul 10, 2013 - Uploaded by ApplianceVideo.com
Hotpoint, GE, RCA Washer Repair - Does not spin or drain - VWSR4150DAWW ... Fisher & Paykel ... my washer won't drainnor spin. what is the problem? .... But in the end, this video helped me fix our washing machine.

How to repair a Fisher Paykel Washing Machine

www.instructables.com/.../How-to-repair-a-Fisher-Paykel-W...

InstructablesHow do I remove the lid on a F&P intuitive eco washing machine to get to the motor panel?? IMadeIt ... It runs until the spin cycle and it drains but won't spin.

Error code 130
Watch this
Fisher and Paykel 130 10000010 Error Code Fix

Hi just read your fault.Now from the information in your posting the lights that are on when the machine is beeping are the 3,4 and 8th lights.Now these lights are in a row of 8 lights and you started from the left.So from left to right the lights that are lit when the machine is beeping are 3,4,and 8.Is this correct?If it is correct then the fault on your machine is called COLD VALVE FAULT.The 3 reasons why this fault occurs is, 1st the wiring to the water valves is faulty,the 2nd is the cold water valve is faulty, or 3rd the control module is faulty.Have you or can you borrow an electrical test meter so I can help you narrow down which is causing the fault.Please reply with additional information on the questions and I can help you rectify this fault.Looking forward to your reply.

Hi just read your posting.Now when the machine beeps do any lights light up to indicate an error code?You have mentioned the spanner shows up but do any others light up as the machine is beeping?Please reply with additional information and I am sure I can help you.Looking forward to your reply.

Hi just read your posting.Now when the red spanner light was flashing were there any other lights that were on.If there was then they will be in your cycle selection row.This row has 8 lights on it.Starting from left to right what lights were lit?Is it the 1st and 4th or the 3rd and 7th ---etc---?Please reply with additional information on the questions and I can help you rectify this problem.

Check the drain pump, it may be overheating and cutting out.

there should be a trouble shooter in the console the blinking lights will tell you what the problem is and the common issues are listed on that paper.

Thanks for the information !