Hotwire ignition key switch

no hotwiring is movies need to order and repair damaged component

Stick the rest of the key in the ignition or slide a small screwdriver in against existing key and use key like normal

need key and ignition switch to start vehicle ---in the movies you can hotwire vehicles --real life need key and ignition system intact to start and drive

Here's a link to your problem. How to Hotwire Car

tell you right now,call and get a tow truck,you are not hotwiring that car unless it is old school ignition.AND YOU DIDNT EVEN TELL ME WHAT MAKE AND MODEL,LMAO!!!

Unfortunately, you will not be able to do that. The key and tumbler are an intricate part of the vehicles "anti-theft system. If the ignition switch or tumbler is broken it will have to be replaced and the theft code relearned. When the key is turned in the tumbler, the switch reads the key code and sends the code to the BCM. The BCM verifies the code is correct and sends a start message to the ECM and allows the engine to start. With out that code verification, the engine will not start.

Well you can just cut the wires to the ignition switch and intall a toggle switch. However, you will need a schematic to know how to attach the wires to the new switch.

You won't be able to hotwire it due to the passlock antitheft system. Read about it in this link.
http://vatspasslockpasskeysecurityhelp.yolasite.com/