Motherboard Led codes - Tyan Computers & Internet

Which type of wire's are they? If you are talking about mobo onboard speaker and front led cables. It should be written on motherboard itself. You need to take it to bright light and try to find out. If it is speaker cables it should be in spkr word. If iti s front LED then it should be colour coding on motherboard. Good luck with that.

http://support.dell.com/support/edocs/systems/dim2400/en/sm_en/advtshoo.htm#1105412
Since that isn't one of the listed codes, it is important to see what the POWER LED indicates.
If it is Flashing Amber, most likely a bad power supply
If power LED is solid amber, then either the motherboard, or a expansion card in the motherboard has failed. Remove any expansion cards, (Modem, sound or video card) try booting again.
If no Change then a motherboard

Hi,
On the motherboard the pinouts on the front panel should be colour coded, and marked with letters like in this picture >>>>>


The connectors are also marked corresponding to where the connect on the motherboard, like in this picture >>>>>>


If the board is not colour coded then the motherboard will marked with the same letters, you may need a strong light and a magnifying glass to see the marks and they are usually at the bottom right of the motherboard.

Regards.

Hi. You may want to check your motherboard for this wires to connect to, First, check your motherboards manual and look where the FRONT PANEL is located, then on the front panel or in the manual itself it will tell you where are those wires should be connected to. If you dont have the manual for your motherboard search it on google and do the same, and if still you coudnt find it over the internet then just look closely on your motherboard and look for the words HDD LED, POWER LED and POWER SW, usually those words or the FRONT PANEL is located on the left side bottom part of your motherboard. Hope This Helps

From your description, I agree with you assessment of a likely Motherboard failure.

Those are really tricky and always vary from motherboard to motherboard.
without the exact model no one will be able to tell you exactly. But I'd recommend that you start out with the power (pw) plug and try trial and error. The only ones really necessary are the pw and reset. the only 2 that are polarity sensitive are the HDD light and pw led.

it is written in the motherboard..
re-reset botton
pw- power botton
hdd led- hard disk led
pw LED- power led

the code is pin 1....

Your motherboard has died .
No beep code explains it all .
LED lights and even fans spins only tells me that your getting power to the motherboard , but No beep code is crucial .
Every motherboard will beep once when your first turn on and beep once again before the Opertional System boots up .
Sorry again for your loss ...

on most motherboard it is possible to read there to set the wires.
hope this helped a little.

Without more detailed information, I really can't help you decipher that code... Since you don't know which specific Foxconn motherboard you're working with, it might be best if you contact Alienware Customer Support for detailed information:

http://support.alienware.com/Support_Pages/Support_Area.aspx

Good luck; let us know what you learn...