SOURCE: do you have a digram to show you how to change belt on inglis dry
Diagram A
Style: Flat with ribs
Installation Tips: Ribs face toward drum
Diagram B
Style: Flat with ribs
Installation Tips: Ribs face toward drum
Diagram C
Style: Flat with ribs
Installation Tips: Ribs face toward drum
Diagram D
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram E
Style: Flat with ribs
Installation Tips: Flat side of belt against drum
Diagram F
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram G
Style: Flat belt
Installation Tips: Side of belt with words faces away from drum
Diagram H
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram J
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram K
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram L
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram M
Style: Flat with ribs
Installation Tips: Ribs against
SOURCE: what's the correct drive belt configuration on an
Hi,
I think you're requesting info on how to route the drive belt, aren't you ?
If that is indeed what you're wondering, the image I've attached should help. It is the Whirlpool/Kenmore image you'll want to go by, Inglis is Whirlpool.
If not please let me know and I'll see if I can assist you further. If this does answer you're question please allow a second to rate the info I provided here.
Thank you for visiting "fixya" and good luck.
macmarkus :)
SOURCE: inglis clothes dryer heats up but drum doesn't
The way to visually see if the belt has broken or not is to 1) unplug the dryer. 2) Remove the lint screen on the top of the dryer. 3) take the two phillips head screws out where the lint trap is. 4) with a flat head screwdriver pop the top of the dryer up by sliding the driver inbetween the top and front of the dryer and pry upwards a little. 5) You'll now see the drum, if the belt is not around it its broken, and if it's visible try to lift it. If it taught, its good. IF THE BELT IS BROKEN OR LOOSE CONTINUE TO NEXT STEPS 6) on the left and right upper inner sides of the dryer you will find two screws, one on each side, remove these and the front should be easlily remove. 7) once off you'll be able to easily see the motor, the belts idler pulley, and everything else.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3
315 views
Usually answered in minutes!
×