At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
"yellow clear" then press 1 0 7 and hold down stop.. go into copy sp and enter 7 8 0 7 and then press " # " press the execute button.. when it says done power down from the red switch.. then power back up.. that will clear the error.. but you may need parts if the error returns
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The correct way to get into service mode is to first press the Yellow "CLEAR" button then press the numbers 1 >0>7 then press and hold the Red "STOP" button.... Good Luck
We are assuming that you are talking about Error Code SC 221 This code is a Scan length detection problem. 1.Disconnected Sychronization Detector 2.Bad LD-Unit/BICU Board SOLUTION: Replace the Laser Diode & Laser Sync detect board
The machine has no fuser oil. Fill the little tank at the back side of
the machine. If the tank is full, check the tubes, oil pump, and oil
sensor.
Reboot the machine to clear the SC.
The problem will be solved
you do not need to clear the memory print the configuration page and see which driver is supported: it can [RPCS] or [PCL 5e] or [PCL 6e] or [PostScript] if you are using the driver which the machine does not support she will print documents as you say some kind of codes.
The error is about the fusing unit for to reset the code you must enter into the service menu and reset the SC code 517 For to enter the service menu you should do the follow steps : 1.Enter the service menu by pressing the follow keys in order: yellow key[clear modes] then press "107" number one after other and then press and hold the red key [clear/stop] 2.Hold it down until service mode do not appear if not appear after 10 seconds try again. After you will be in service mode press the follow numbers :5810 and then will apear on the screen "SC reset" set the value from "0" to "1". Then turn off and after 5 seconds turn it on the machine. Please replay if this do not help and write the SC code good because i cannot find the code SC517
×