Top 20 Leeson Reversible Electric Motor 3/4 HP - Page 6 Questions & Answers

Not familiar with your torch, but does it have a trigger? Possibly goes behind the trigger?

Apparently AMT is no longer in business. There may be a similar Craftsman model in case a manual can be located for it, but link below suggests they did not locate manuals.A Craftsman shaper from the 1970's manual for sale: https://ozarktoolmanuals.com/machinemanual/craftsman-wood-shaper-113-23930-owners-instructions-parts-manual/You might try posting a forum request on the following site, in case anyone c an assist.http://vintagemachinery.org/mfgindex/detail.aspx?id=29&tab=3https://www.shopyourway.com/questions/1192269

Do you mean tremclad? You can either leave it alone and hope it eventually dries, or you can remove it and try again with the right kind of paint. tremclad was made for metal and rust, not cupboards. I suggest you wipe it off with a suitable solvent, perhaps acetone will work. Once you have as much off as possible, sand down the cupboards and paint with latex or even oil base house paint, or if you sand all the paint off you could use a stain. At any rate, use the right product for the job.

Have to pull off the front face and panels access from the front of machine

most sanders of this type come with a baseplate that punches the holes. If you received used you may be able to buy a plate but cheaper to just punch your own

Might be the belt also check to see if there aren’t any loose parts in it needs to be serviced

Part #2-612102-01 Best bet is ebay as they are no longer available from the maunfacturer

Broken wire in the winding of the armature.....It will have to be replaced......Cheaper to buy a new Dewalt or Millwaukey............

manufacturer -tool repair shop online search

You will get all the information on Toolbox & Hardware from here https://toolboxwidget.com. Download your PDF copy today or email us to [email protected] for ordering book.

Contact Jet directly to inquire.

the pin that makes contact with and drives the nail is coupled to a piston.either that connect has failed OR the piston is stuck in a bind(probably a faulty o-ring)

fixya doesnt sell products -manufacturer or online search

Best place is to ask at a Canadian Tire. If you can find the part number on the rotor that would help a lot as you can search for that part specifically online or go to local small motor repair centre for the part or it's equivalent.

google SARS contacts. in Africa asking in USAand on wrong forum moving you out of computer fix to misc.first hit, OMG., am I MVP of google NOT.THE AFRICAN IRS.GOV , YOU ARE TOAST.https://www.sars.gov.za/Contact/Pages/default.aspx

Contact Performax to inquire.

bypass or off valve failure

Follow the link. http://ezinearticles.com/?Smart-and-Easy-Steps-to-Load-the-Bostitch-H2B-Stapler&id=5268446

Sounds like one of two things out of adjustment or worn out.

Remove the piece of Wood that is jamming the Feed rollers