Top 20
Leeson Reversible Electric Motor 3/4 HP - Page 5 Questions & Answers
Cal-Hawk 240-3016 Bench Sander. Does anyone have a user manual?
Manuals aren't thick on the ground - a google search provides only vague references, however all is not lost as this type of sander is often a generic type label engineered with only minor variations to reflect a price range.
The machines tend to be so similar a manual for almost any brand that looks even vaguely like yours will provide the basic information.
The machines are intuitive to use and you shouldn't have any problems and the hardest thing about them is cleaning the disc prior to sticking a new abrasive disc on.
They are a very useful machine especially to a woodworker and the disc sander will allow the end grain of timber to be sanded smooth accurately to the desired angle.
How do you turn off water under sink to change reverse osmosis filters? I found the football shaped valve that goes to the hose. I turn the valve and water still runs so what am I doing wrong?
Open the RO tap and drain the RO tank (capture and use later). The tap will run a steady stream until tank empties. When tank empties the steady stream will switch to a drip, drip, drip,... This is normal and is the production output rate of the system.
If you capture the drips into a measured container a typical rate is 1 quart per hour, more or less given input line pressure and condition of system filters. Time how long it takes to capture a cup (8oz) and do the math.
The RO feed line is likely a piercing saddled type valve. It will take several turns (clockwise) to close the valve. Keep turning CW until it stops. With the tank empty (tap will drip, drip, drip,...) close the filter feed line valve and the drip, drip, drip will eventually stop, indicating the system no longer has water pressure.
How do I unjam my bostich T6-8 stapler and my old model T5-8 tacker?
How to Unjam a Bostitch Stapler
- Disconnect the construction stapler from the air supply. Use a hammer and punch to do this. ...
- Push the driver upwards and past the jammed staple. Do this by putting the punch at the tip of the driver, which you should see coming out of the nose. ...
- Tap the hammer against the punch and the jam should clear.
https://homeguides.sfgate.com/how-to-unjam-a-bostitch-stapler-13401638.html
How do you load a Arrowv nail master 2 et200 brad nail gun?
LOADING NAILS
* Disconnect the tool from the power source when loading brad nails * Tilt the tool or lay the tool flat, so the nails will not drop out while loading
*Press lever (A) while pulling slider (B) backwards Place the nail strip into magazine (C) (maximum capacity 100 nails)
Can’t get staple to come out
Didnt give much info to go on lol. Make /model and a little more detail on your issue will be needed before anyone can try to help you
The sanding belt keeps coming off. The tracking adjustment isn’t functioning.
This belt should be mounted so that the overlap trails when the belt sander is used, sometimes these belts will have arrows indicating the direction of rotation but not always. The arrows usually disappear after a bit of use anyway so if you change grits or re-use belts it is good to know which way to run the belt by looking at the join.
Here another fix that has worked for me. Take some ordinary electricians tape and make several laps around the idler pulley on the belt sander. Put more thicknesses near the center of the idler, than the outside. This effectively builds a small crown on the pulley and makes the belt stay centered. Also, always relieve the tension on the belt when not using the sander. The belt can stretch and tracks poorly if this happens.
Not finding what you are looking for?
