20 Most Recent
Keurig B50 Coffee Maker - Page 3 Questions & Answers
My keurig k65 won't brew
The problem is in the exit tube. Clean the top tube with a paperclip end and free it from deposits that collected inside. Keep Filer up to date 3 months or less to keep particles from entering the heating chamber. Use Distilled water for less particle builup.
Transformer
Electical dysfunction and needs to be replaced.
The coffee stream is weak
Clean the Kcup holder.
Cleaning the K-Cup Holder
- Remove the K-Cup assembly
To remove the assembly from the brewer, open the cover by lifting the handle. Grasp the top of the K-Cup Holder with one hand while pushing up on the bottom of the assembly from underneath with the other until it releases. The K-Cup Holder is dishwasher safe.
- Clean the Funnel
The Funnel can be removed from the K-Cup Holder by pulling on it until it snaps off. The Funnel is dishwasher safe. To replace it just snap it back onto the K-Cup Holder.
- Clean the exit needle
The exit needle is located on the inside bottom of the K-Cup Holder. If coffee grounds or cocoa mix gets clogged in the exit needle, it can be cleaned using a paper clip or similar tool. Remove the Funnel from the K-Cup Holder, insert the paper clip into the tube and move it around to loosen the clog and remove any debris. Please note, you cannot poke all the way through the needle as the opening of the needle is located on the side and not the top.
- Install the K-Cup assembly into the brewer
After cleaning, align the K-Cup Holder tabs with the opening placing the two front tabs on the bottom and the single tab on top and snap it into place by pushing down on the top rim.
Not finding what you are looking for?