20 Most Recent HP LaserJet 1320n Printer Questions & Answers

Firstly I doubt that economode is set by default, but maybe the printer is in economode for some reason. Secondly I would normally expect the problem to be the toner cartridge but assuming you have checked this my suggestions are as follows. 1. Run two internal prints from the printer. a. By pressing the green "go" button briefly. b. By holding the green "go" button for 5 seconds. The first print should give you an indication of the print quality, if it is good then the printer itself is probably behaving normally. The second print will tell you exactly how the printer is set up. This includes whether economode is on or off and what print density it is set for (default is 3, range is 1-5). 2. If economode is on or the print density is lower than 3 the easiest way to fix this is to do a cold reset on the printer as follows. Important note: This will reset the printer to factory defaults, the only setting that is critical is the jetdirect setting. Since you stated that your printer is a 1320 and that you are running DOS I am assuming that it does not have an "n" (for network) suffix eg 1320n. If I am right in this assumption you can ignore the jetdirect comments above, if it is a network printer the second printout from 1a should provide the jetdirect information which you may need to keep for future reference. Cold Reset Procedure:- a. Turn the printer power off b. Press and "hold" the green "go" button whilst turning the printer on. c. Continue to hold the go button for at least 5 seconds and until the amber attention light turns on (triangle with ! in the middle), this should occur before 15 seconds elapses. d. Release the go button. Factory defaults should now be reset and you can check using 1a whether any changes occurred.

isbcomputer.com is a dedicated online store offers Printer Spare Parts, Formatter Card, Main Board, Power Supply Board, Flat Cables, Fuser Pressure Roller, Gear, Sensor, Scanner Units, HDD Parts, HDD PCB, Hard Disc Drive Spare Parts, Data Recovery, Refilling Products, Jet Image, Toner Powder, Toner Drum, Toner Cartridges, Laptop Accessories, Power Adapters, Computer Accessories, Computer Services, Computer Peripherals and many more Computer and Printer related products at one place with best prices. Visit - http://isbcomputer.com

problem your os please

you need post script level 3 support printer.You should buy hp laserjet 2200 or 2300 or 4250 it has default post script driver

Dear Sir

My printer is laserjet 1320

PCL XL error
Subsystem: KERNEL
Error: Illegal Tag
Operator: 0x1b
Position: 6




Pls. This problem solution give me.

Clean the pickup roller and separation pad. Pages 52-63 of the manual at the link below http://www.partsnow.com/docs/service-manuals/HP%20LaserJet%201160%201320%20Service%20Manual.pdf

down load the drivers for the printer from the net type in driver down load for the make and model of the machine then down load from the correct page

reinstall driver

No, the page count is not on the test page. You need the configuration page. Press the GO button and hold for 5 seconds. The yellow light will come on and you can release.

hmm i believe you might have a hardware problem. can you explain the problem more in details like your paper get stuck from the feeding place below or before getting out. this kind mostlt called paper jam or stuck

pcl xl error subsystem: kernel error : i llegaltagoperator : 0x2position : 54

Try looking in the driver properties for that printer. You should be able to turn on/off the duplex feature. Also try the "Paper Handling" area in the printer's menu.