20 Most Recent Rangemaster Classic 90 (Electric) Kitchen Range - Page 3 Questions & Answers

yes there will be a cooker switch located somewhere in the kitchen & from that there will be a supply to a cooker point witch is a white box that is no bigger than a single socket.
there should or should have been a 10mm heat resistant flex running from that to your cooker.
if there is a flex then your ignition mite run off a 3volt battery.check your manual if not then try this web site :
http://www.rangecookers.co.uk/installation-guide-content,MGQJD.aspx

To get the correct dimension, you could make up a template out of thin carboard to do your testing before you cut the metallic duct.

You will need to match the area of square inches of the duct, no matter the shape. If it's round the formula is (pi (3.1416) x radius squared). If it's square or rectangular, it's L x W in inches. Your local home improvement store (if there is one) should stock various adapters and metallic round duct.

Note that since this is being used in a kitchen, the duct should be metal and it should vent to the outside unless it is a recycle hood.

Let us know if that helps...if not we'll try again!

There are two elements on the grill, left and right. One has failed and needs replacing. Can't tell you how, we haven't got that far, but we bought replacements from e-Bay £9.99 each + £2.50 P+P. Official suppliers charge £21+.

Beth

My oven stopped working due to a problem with the clock, i coudn`t get the clock off of p100, ( clock broken probably chip broke). So i by passed the clock by removing the blue negative wire just by pulling it out of connection. (easy) took seconds to fix.I don`t need to use a clock, so i dont need to replace it. So simple to fix, anyone can do this.

I presume it is gas powered? They are available in all sorts of dual fuel variations. When you operate one element all the igniters spark. It sound like the igniter switch for the oven need adjusting. They normally operate on a cam so when you turn the control knob, the cam lobe runs up onto the micro-switch and then off it again creating a ignition spark on the way. It is a gas appliance, so call for service. Various other suggestions here https://www.google.com/search?q=Rangemaster+Professional%2B+oven+igniter+keeps+clicking ..

Remove the flame spreaders and rings from the 3 rings you use the most, including the faulty one. Put them in a large pan cold water, add a teaspoon of dish liquid and slowly bring to a simmer. As soon as it want to boil over, blow on it and turn the heat off. Leave it to cool. Scrub with a plastic pot brush making particular attention to the holes. You had a blocked one which is the one that directs the gas to the spark igniter. Rinse and dry them, and replace to the hobs.

Video help

The thermocouple needs replacing. That is what tells the main gas valve to open when you turn the knob.

Video help here, just in case you never managed it back in November 2018 :>D

Question edited for clarity and spelling of Model Range 'Tecnik' with a 'c'. Just lay it back over. Its purpose is the stop the back panel getting hot and to keep heat in the oven cavity. https://www.fixya.com/support/t779759-tecnik_tkc_1285_access_fan_element and https://www.google.com/search?q=tecnik+tkc1285+replace+oven+insulation Same for any oven make ..

Ands like a thermostat or thermal fuse issue.

possible control board

check and test thermocouple

If the LPG cylinders have the correct pressure regulator, no need to use an extra one but any regulator must be set to the correct pressure or removed.

Faulty thermocouple, suggest you get it replaced.

Its the spark box repeating check the elcrtode is not damaged /cracked . if not it sound slike a faulty box