20 Most Recent Vizio P2 42 in. HD-Ready Plasma Television - Page 3 Questions & Answers

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/

Troubleshooting to Plasma Displays is a very skilled work. If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/

Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. Do asearch by type in the brand name of your device at its search box. http://electronicshelponline.blogspot.com/ It will be best to replace the power supply regulator board as card basis.

Main power regulator board or back light inverter board can be the cause to this buzzing noise. Contact any service technician to troubleshoot. http://electronicshelponline.blogspot.com/

Refer its user manual for details. http://electronicshelponline.blogspot.com/

No, it has no infra red transmission capability

I already answered this

We are available for conference Today and Everyday. We will assist you in repairing your set. The problem is:
(1) Get TV remote and go to close caption and turn it off
(2) Get your cable remote and check to see if you accidentally turn on close caption. I have seen this a lot of times
Please join in conference for any additional help if needed

LOGIN

Circuitcity

-------------------------
Fixing TV is Easy.Fixing Customer is Priceless!

http://support.vizio.com/

If the main system control memory IC has damaged, this kind of fault can occur. To get more details, http://electronicshelponline.blogspot.com/ Pull up older posts. Blinking codes to many brand TVs are given. Before doing anything, just make it a hard reset. To make it so, just unplug the TV from AC mains wall socket, and re-plug it back after 10 minutes or so.

I had the same issue. I could get the tv to work intermittantly by pressing on the boards while playing. This points to bad solder joint, so I resoldered every molex plug connector, and it nows works like a charm.

make sure your hd cable connection from your cable box is going to an hd connection to your tv.[via hdmi, dvi,or componant.] if you have a different hook up such as rca out or coax out, these are not hd connections and you are probably streching out the picture.look at the rear of the tv & cable box and see how the connections are.the hd hook up to the hd input should make the picture the right size only if it's set on the hd input channel.hook up the dvd player to a aux/line in or video/source input and try changing the picture size. you may have to play around with it till you get it the way you want.
hope this helps.
wg

were r the fuses in my tv located at

If you notice a Very Slight change in the black when you turn ON the TV, then this may be possible to fix at home by you.

1. Unplug the TV and press the Power Button on the TV.
2. plug it in and try it again
3. if no picture, check the User manual for the customer reset method
4. try doing a customer reset
5. if this doesn't work, you need to get it serviced.

This sounds like an inverter problem if the Backlight is not lighting(no slight change to black when TV powered on)