Top 20
AO Smith A O Smith Motors Centurion 1.5hp 115/230v Aluminum Keyed Motor Questions & Answers
I am trying to remove a Centurion B849 from the
I'm not sure I understand your question.
To get the impellar off of the shaft, leave the motor bolts on.
Open the back end of the motor, there should be a slot in the motor shaft. Use a screwdriver to hold the shaft from rotating and grab the impellar and rotate it counterclockwise to unscrew it.
It sounds easy, but the impellar is probably somewhat corroded on.
Gary
How to wire the capacitor on a a o smith motor bn37 115 volt 11 amp
The 4 terminals are actually only on 2 terminals!
If you look closer, you will see that 2 terminals are actually on SAME post. So...
place a wire into one spade terminal, and then Cross over diagonally with the other wire.
it does not matter which wire goes where. Just be diagonally across from each other.
Is frame 56J interchangeable with other frames ?
When looking at a frame size you cannot change from the "J". This letter referres to the method the pump housing will bolt onto the motor. The numbers 56 refer to the physical size of the pump, specifically the distance the center of the shaft would sit off of the surface on which it rests. You can sometimes go from a 56 frame to a 48 frame but you will need to add a spacer given the smaller physical size. Some pump bases will have a stilt that can be switched around or removed to accomodate different motor barrel sizes.
Not finding what you are looking for?