Pool & Spa - Recent Questions, Troubleshooting & Support

depending high voltage 220 or low 110 volt see side of motor for wire changes and find out voltage to unit first

Pool Pump Pool &... | Answered Yesterday

Soapy water never worked for me... Pour kids bubbles into a bowl and use a paint brush to spread the bubbles on the top ring. If there is a hole you'll see it begin to blow a bubble where the hole is.  patch with vinyl repair kit.

Intex Easy Set... | Answered 2 days ago

Could be first signs of algae growth.
Check the chlorine levels.
Check the pH levels.

Pool & Spa | Answered 2 days ago

check switch for power there pilot supply is blocked clean copper thermal wire that usually goes first they are only £5

Pool & Spa | Answered on Jan 20, 2019

Make sure the piping to the controller is at least 3/4" inner diameter (ID). 1" is better still. 1 HP should be plenty.

Pool & Spa | Answered on Jan 17, 2019

My EasyTouch was set to "Man. Heat>ON". Once I turned that off, it worked from ScreenLogic.

Pentair Pool &... | Answered on Jan 16, 2019

Not finding what you are looking for?
Pool & Spa Logo

27,048 questions posted

Ask a Question

Usually answered in minutes!

Top Pool & Spa Experts

Jay Finke
Jay Finke

Level 3 Expert

1389 Answers

Bill Jordan

Level 2 Expert

373 Answers

David Spradling
David Spradling

Level 3 Expert

9802 Answers

Are you a Pool and Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides