20 Most Recent
Emerson MW8102SS 1100 Watts Microwave Oven - Page 3 Questions & Answers
How to change interior light bulb Emersom
If
there's no obvious removable cover over the bulb (most often on the
rear or side) and the owner's
manual doesn't address it, then disassembly will be required.
You'll need to remove
the outer cover (wrapper) to get to the bulb.
Always unplug a
microwave before removing or installing any bulbs.See these links before
proceeding:
http://031d26d.namesecurehost.com/mwd/safety.txt
http://031d26d.namesecurehost.com/mwd/disassembly.txt
The
screws you need to remove should be pretty obvious, but a special
driver (such as a T20H type or GTXH20-100) may be needed.
Be sure to put all the
screws back in the right holes, since some may be special grounding
screws.
Bulbs (or 20A ceramic
fuses) can be had locally in most
grocery stores, hardware stores, home improvement centers, and big box
or department stores.
Many models use halogen
lamps. You must not touch halogen types with your bare skin, as the
oils
will shorten the bulb life.
We're
happy to help you with free advice and we'd appreciate your thoughtful
rating of our answer.
My problem is top door
Go to Sears's website and use the partsdirect section. It will ask you for make and model and usually shows a diagram with part names and numbers. I use their site all the time and it hasn't failed me yet.
My child lock the microwave
1st try unplugging it for a couple days. then try a diff outlet when u plug it back up. u may also have to reset "the brain" with a code (by using the buttons) and a new fuse never hurts. (see manual) and last but NEVER least, u can slap the "mess outta it!" you'd be surprised.
yours truely,
maintenance man
Everything works but just want start
It seems your have a general failure in the power control or switch failure on the unit. Since your unit has power, and things lite. it is more likely you have a control/switch problem,
Microwaves must be serviced by technicians due to the inherent dangers involved in repairing these appliances. Internal capacitors can retain a lethal electrical charge even though the unit is completely unplugged. A microwave radiation leakage test must be performed on the unit following any internal component repair.
I need to know the
Maybe I am confused, or don't understand your question. But your model runs on 110 current and is >>>>>>>>>>>> 1,100 watts. Breaker in panel needs to be 20 amp to run best, and nice to have on separate circuit if able. Thanks mike
My country use the 220 volts system do have to use
If your microwave is wired for 220 volts AC and your country standard house current is 220, and the plug is of the proper configuration, plug it in.
Standard microwave size is around 1100 watts at 110 volts Normally, two times the voltage is 1/2 the wattage. Ohms law, Voltares Law and Watts Law apply.
If your microwave is 1100 watts at 110 volts --- yes you will need a step- down transformer of some type.
Smells like it burns
Hi acontrera108
we both are same problem, did you get some answer ? plz tell me how did you fix it..
Thank you
Sky
Microwave stopped working all of a sudden. NO
the most common problem with microwaves is the door protection circuit blows a fuse. the door catches operate switch that if they do not operate correctly( normally after the door has been slammed). the good part is they place the fuse inside the casing. so remove the power open the casing( several screws) and check all the fuses in side.
Not finding what you are looking for?