20 Most Recent
KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher - Page 5 Questions & Answers
The dishwasher door keeps popping open
I have the same problem and it appears that everyone else who has replaced the door seal runs in top this issue. This is a new seal design that is different from the original. This new seal is obviously poorly designed is placing too much pressure on the door causing it to either not close, or open mid cycle. I am presently duck taping the door closed when running the machine in the hope that the heat cycling the new seal will eventually cause it to deform and relieve the pressure. I see that other have attempted to help the process by increasing the release pressure on the latch. This will be the last Kitchenaid large appliance I purchase.
KUDS01FL Dishwasher - The "clean"
Hi,
Read :-
http://servicematters.com/clean_led/8178496.pdf
http://servicematters.com/clean_led/blinking_video_body.htm
Let me know,if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
Dishwasher not draining completely-suds left
Dishwashers shouldn't have suds so somehow dishwasher liquid was introduced to the dishwasher. Vinegar, alcohol, or a small amount of cooking oil might help eliminate the sudsing.
Kitchenaid dishwasher making funny noises while running
HI. this sounds like a busted impeller in the pump housing. there are two impellers. one for the wash and one for the drain. the drive shaft will strip the impeller center nut, causing this noise.
I would inspect the pump housing for lose impeller action. replace the faulty impeller if found to be damaged.
The clean light keeps blinking and the dishwasher
Hello & Welcome to FixYa
Flashing clean light is reset by pressing two buttons in sequence 3-4 times, to reset your dishwasher press these buttons in sequence:
High temp wash-heated dry-high temp wash-heated dry
Please get back to me if you have any other questions.
Kevin
Kitchenaid dishwasher not heating up
Can you check the near the swiches? this is located on the top of the door, you may have to remove the inside plastic covering. The switches get durty from steamed debre, or may have a connector pulled apart from the door being opened, and closed many times. Turn the power off, and take a look see behind the switch panel.
Not finding what you are looking for?