20 Most Recent
KitchenAid KGRA806PSS Gas Kitchen Range - Page 5 Questions & Answers
I have a 6 month
Hi.
F6-E0 means that no communication is detected between Oven Electronic Control and connected devices (switch board).
If switch pulse return line is not connected, electronic control will display F6-E0 within 60 seconds after power up.
Try tripping the circuit breaker or disconnecting the power cord, to cut power to oven control for about ten minutes.
If that does not clear the error code, then you will need to have electronic control replaced.
If you want to locate an authorized technician, please ring the number listed on the owner manual.
Try first disconnecting power to reset the control board, that may fix the problem.
Regards.
How to fix sensor error on KERS807SSS Kitchenaid
THIS PROBLEM IS MOST OFTEN CAUSED BY A DEFECTIVE MAIN CIRCUIT BOARD, THERE IS NOTHING YOU CAN DO TO RESET THIS, IT IS A HARD FAULT CAUSED BY A DEFECTIVE CIRCUIT BOARD AS I STATED ABOVE, CALL SERVICE, DON'T TAMPER WITH IT OR YOU WILL VOID YOUR WARRANTY AND END UP PUTTING OUT $100'S TO FIX THE PROBLEM.
Hi,I have a kitchenaid gas stove and the oven
Most likely a bad glow bar ignitor at the oven valve. It must read 3 amps or more to activate the gas valve. Turn the gas off,put a clamp on amp meter on the ignitor wire and turn the oven on. If it reads less than 3 amps,replace the ignitor.
Blown fuse inmy kitchen aid range
if you havnt lost your main input 120/240 voltage then check around the control panel,you'll probably find a special control fuse in this area
Oven shut down
IT IS THERMOSTAT IN BACK PANEL ABOUT A 48.00 PIECETWO CLIP WIRES AND TWO SCREWS IT IS NOT IN TOP OF STOVE IT IS IN FLAT ACCESS PANEL BELOW
Door locked: display panel not lit.
Unplug the appliance and the next day it will work again. Do not use the self clean cycle or I will have to spank you! Did you not know that 900 degrees for 3 hours can harm delicate expensive electronics. Get some easy off and clean that oven or get ready to spend some serious dough on fixing this puppy down the line.
If you need further help, reach me via phone at
https://www.6ya.com/expert/dan_73bbd84fe1d95b61
Lock on oven is locked and door open
look towards the center of the door, next to the "self clean latch" youll see a thin metl "plunger", try pressing this in and then restarting a clean cycle, then quicklly cancel clean it should reset the lock/latch mechanism
Not finding what you are looking for?